dapiper Posted September 8, 2009 Share Posted September 8, 2009 Completed MM 300ZXT CV convertionon my '77 280Z and bar hits shaft. Anyone have a solution? Which bar will fit? Are there shorter end links? Quote Link to comment Share on other sites More sharing options...
240hoke Posted September 8, 2009 Share Posted September 8, 2009 Just cut the spacers down in between the end links to change the over all height and it should clear. Mine clears fine, but I am using the 240z rear mounted bar....might can switch to that if the front bar doesn't work out. Quote Link to comment Share on other sites More sharing options...
Bartman Posted September 8, 2009 Share Posted September 8, 2009 I had to remove my end link spacers completely, but it seems to work fine with no binding even while autocrossing. http://forums.hybridz.org/showthread.php?t=125185 Quote Link to comment Share on other sites More sharing options...
dapiper Posted September 9, 2009 Author Share Posted September 9, 2009 Thanks for all the info. Will advise our solution. OBTW, my bar uses front chassis mounts. Quote Link to comment Share on other sites More sharing options...
pallnet Posted September 9, 2009 Share Posted September 9, 2009 Yeah lowering the ends will solve the issue, it did for mine. pallnet Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.