fentin_fury

I tried emailing Silverline - bounces back. Are they still in business? Another question - anyone run a steering quickener - say 1.5:1 with an electric system?

looking for 18x11 or 17x11 5x114.3 (4.5) 240z Q found!

It has been a long time since I have posted here however I still come back for the wealth of information available on this site. Since my last post on my build I am on my third engine... Current block is a new N1 Block with a Nitto stroker kit. and some new aspiration..... header was just a thing of beauty! BW Twin Scroll This winter I am on a weight loss mission (for me and the car) and have ordered a bunch of goodies from our friend at Ztrix who was very helpful. I also have a new sponsor who is providing a much needed gearbox (I tend to eat stock Rb25/32 transmissions) . I am getting an HGT sequential gearbox It will be an exciting down time and hope to have the Z back and competitive in the new year. If you are interested check out datsunracer on facebook or my website. Happy New Year to all at Hybridz! Q

I just ordered a new one (replacement) I will send you the part number.

ViPEC finally installed - not bad 8 months later than planned Car starts and idles much better than with my old microTECH LT12 - and that I played with for years - so I have high hopes that tuning will be much easier/better. Will update once I spend some more time with the system. Anyone else here get one installed? Q

I have begun installation of my ViPec V88 - will let you know how that goes. I am replacing my Microtech LT12S - which I felt had some limitations - mostly the inability to run in a closed loop mode. Q

check out around 1:40 Q

Friends, I am looking for a PRE 81 Browining BLR magazine (.308 or .243). I can't find one anywhere - If you find one grab it for me! Q

Stony - you are welcome to my microtech lt12s with X6, wideband and data logging. If you like it you could purchase it. I am switcing over to a vipec v88 and the microtech will collect dust. uses stock CAS, temp, TPS, water temp, air temp and built in 5bar map. Setup up for my car with 700cc sards. Sequential ignition - will use stock coil on plug. programmed and ready. Q

drew - pm'd you. I was running on R888s. 245/45/16 on the rear. I could have turned up the boost but that would have broke something for sure! I was running at 20lbs boost. Q

Well i went - and tried a few runs. I get a lot of wheel hop/spin - shakes everything quite badly. Yesterday was quite cool and wet - but here are some time slips. I have not done this before so no making fun . I am the faster car in these three

The BC "kit" consists of his crank, eagle rods and CP pistons. No real kit - that worries me a bit. I was checking out JGY for prices - and they are now carrying Tomei parts. I have had good luck with these guys. ohh - and if anyone has a RB26 block with girdle and squirters - I am in the market

Well i am more of a road race - Solo 1 type - and built my Z more for that purpose but I am going drag racing today. I will post times so you can all have a smile at the end of the day. On another note I am going to build a spare short block. I want a stroked - 2.8l. I debated the RB30- just to much work in my opinion to swap out on a weekend. My question is has anyone here tried the Brian Crower crank? I like the Tomei kit - and my Tomei components I cannot complain about but they are not the least expensive option. Q

Matt you'll be back! Q

install begins this weekend - hopefully painless