450HPZ

I am in need of a 1981 280zxt ECU Hanness is known good working condition. It must be from a 1981zxt.

JWT makes them for 115.00

I have the perfect T-5 for you, comes with a Hurst short shifter,custom aluminum flywheel, and oversized JWT clutch. less than 50 miles on them. 450.00

I have almost everything you need.

did you get everything you need? If not I still have my setup.

BUMP

I have a aluminum flywheel and JWT clutch kit for sale with less than 50 miles on it. I will sell it for 400.00 I paid almost 1200.00 for it.

I have everything you need. I have the JWT 450hp setup for 400.00 comes with everything you need.

I have an ECU from JWT and the Dizzy as well (450hp)setup for 400.00

I have a T-5 tranny for sale

I AM IN THE NEED OF A GOOD ECU HARNESS FOR A 1981 280ZX TURBO. 82/83 HARNESSES WONT INTERCHNAGE. IT HAS TO BE FROM A 1981 TURBO.

I am getting a pulse signal to the injectors, but its very dim on the noid light. I have verified it to be weak on the ground side circuit, and I have verified pins 101-106 are grounded solid. I dunno where to go next? Its a 1981 280zxt . I did a cont test,a load test and they both came up good, but still weak ground on injector harness side.pins 101-106 inside the ecu are connected so I know its not an injector to ecu issue because they all do it. nothing else is affected in the car, but the poor ground wont allow the 12v to the injectors. The power side is great, its only the ground side. I have even installed redundant grounds because the Z cars are know to have problems.

I am still in need of a 81-83 turbo ecu harness if anyone has one for sale.

I prob have one around here somewhere.

I am in search of a good ECU wiring harness for a 82-83 280zxt. send message or e-mail me at morrisonjr@northstate.net.

I would start by checking the head temp sensor resistance at the ecu...

put them on their own circuit.....

Should just screw right in.

I am in need of a 1982-83 turbo distributor quickly! And shipped to 27360... thank you!

I need the kick pannels for a 280zx as well as the radio console and wiring harness ASAP.......

I am also in the market for a limited slip rear end from a 88 300zxt, if anyone has one!

Looks like im in need of all rear interior parts, as well as the driver/pass kick pannels, and radio cluster with harness. Color isnt important, but condition is! e-mail me at morrisonjr@northstate.net if you have these parts please!

I am in need of blue 81-83 interior parts, mostly radio cluster and harness.

I have a programable speedo im onstalling from Autometer I wanna know if anyone elese has done this. Is says you need the speedo sensor to go into the tranny but I dont know which one to use with the t-5 tranny I have.