riverz

I have one if you still need it. Still attached to the manifold. Let me know

I still have mine but still not in country

I have one not sure the gear set in it but I have a 3.90 that is not installed. Also have axles, mustache bar, and flanges.

I have a set but there are two kinds. The kind that mount to the glass and the kind that mount to the hatch with hings and lock pins. Mine is the hinge type let me know if you are still in the market

I live In crestview and really like the area. Pm me and I will give you my number and answer any questions you have

That is one of my favorite shows looking for it on dvd. Finnally got to see the movie it was really good.

I have two and will make you a deal on one and I am local save on shipping Pm me. Jason

It will not bolt up to the z series motors tried on my 720 didn't work.

How does the the internal regulator work. I got 12 v on the batt lug and 12v on the red and white wire in the connector what is the green wire in the connector? Any info would be great thank you. Jason

Ok after more looking I was wrong it is externaly regulated So I think I am going to get a new regutalor and see what happens.

The alt will not charge but it is good the car is a 77 and is internally regulated. Can some one tell me which alt wire is suposed to do what. my haynes manual only give the wiring dirgram for the externally regulated alt. Thanks Jason

The carbs are dumping fuel out the front after the engine is shut off. What would cause this? I tried another pair but the motor will only start with a shot of starting fluid. This is really frustrating. The first set are three screw and the second ones are four screw. both were said to run when removed. Can anybody help.

If anybody gets a chance you need to go to the reno air races. Usally in september. The only place you will see p-51s and like aircraft 100 feet off the ground flat out around pylons. You also can get up close with a pit pass. Lots of old planes and some good stunt flying.

I got the transmission apart and the shift fork for fith and reverse is bad. Every thing else looks good just need to find a new fork. Still can't beat it for 200 and very little rust only whole in the truck is in the bed where it got wrecked.

Sorry Its a four cyl.