illusioneclipse
-
Posts
10 -
Joined
-
Last visited
illusioneclipse's Achievements
Newbie (1/14)
0
Reputation
-
Ive been looking for 3” exhaust for my rb25det swap into 78 280z and no luck. Bought CX Racing and it fits horrible. Mid section too long. Downpipe hits firewall.
-
Did you find out what the problem was?
-
I am running stock 78 280z gauge which is mechanical cable. I searched around and came across Navarra speed sensor for my rb20det transmission. The length of the sensor just seemed too long. It is the right sensor for rb20det transmission with stock 280z gauge?
-
It's what you used for your RB20 transmission?
-
Mating the Z Gauges to the RB Engine Swap Sensors Etc
illusioneclipse replied to Mike Rowe's topic in Nissan RB Forum
I ordered this part no for my 78 280z stock speedo with RB20 transmission. It seems longer than what's suppose to go inside. Is this the right P/N for RB20 transmission with 78 280z stock speedo? -
Mechanical Speedo drive swap into RB25 Gearbox
illusioneclipse replied to Mike Rowe's topic in Nissan RB Forum
I bought 32702-33G17 but it seems too long for my RB20 transmission? Did I buy the one for the RB25det transmission? What's the right P/N for RB20 transmission for a stock 78 280z speedometer? -
Did you ever finish the wiring? I am in the same boat as you right now and trying to research before I start the wiring. I have a 280z with wiring specialties engine harness.
-
Awesome! Thanks for confirming.
-
inner tie rod question
illusioneclipse replied to zombie-nsk's topic in Brakes, Wheels, Suspension and Chassis
Yes, its for s30, specifically 78 280z. I know my car has left hand and right hand threads. Just didnt know the thread size. Thanks all for confirming. -
Has anyone confirmed this thread size is correct?
-
inner tie rod question
illusioneclipse replied to zombie-nsk's topic in Brakes, Wheels, Suspension and Chassis
Anyone happen to know what size thread is the inner tie rod? I need to buy a replacement nut. Any help is appreciated. -
Techno Toy Tuning Tie Rod
illusioneclipse replied to Keepn it OG's topic in Brakes, Wheels, Suspension and Chassis
Hi, I am trying to find the thread size for a 280z driver side inner tie rod. I need to buy a replacement nut to lock my tie rod, and I do not know the thread size. I do know that it's left hand thread. Any help is appreciated.