Search the Community
Showing results for tags 'pans'.
Found 2 results
Floor pans. Are we doing this right?
grayson260z posted a topic in Fabrication / WeldingSo my floor pans fromhttp://www.thezstore.com/pathing/PROD/30-7317 Arrived and we started attempting to install them. Well everything is going well thank you for asking. Except We've met a small snag. Right below the little recessed cup thing where the seat belt retractor sits was a little rusted out and it's at a weird angle to where we don't think we can just weld some sheet metal in there. I don't have a good picture but will get one shortly today. If you guys have ever ran into this problem let me know how you surpassed it. It's the place where the driver floor pan stops and the slanted piece starts up. Only pictures I got.
Floor pans/Seat rails
grayson260z posted a topic in Fabrication / WeldingSo on my 260Z the floor pans are shot. No nice way to put it. And the Dingus that Owned it prior to me I guess was just trying to make it driveable and he just riveted in a little piece of sheet metal in the drivers floor board. Well anyway it has led to a huGe mess in the floor pans and the bottom of the sEat rails look like they have a little structural rust on them. My plan is to get a recaro or some kind of after market seat with the avaliability of a harness to be installed. So my question is would it be worth trying to salvage the front seat rail or just cut the thing out with no discretion? Not to mention does anyone have a few pictures of where they installed the new floor pans and support rails from http://www.thezstore.com/page/TZS/PROD/30-7317. I really want to know how far back im gonna have to cut and also how far up the trans tunnel I need to tear the fabric. Thanks guys!