Rear brake line routing

[seattlejester]

Howdy,

 

So I've been taking the rear wheel on and off while updating some of my suspension bits, and I noticed that the rear brake line bracket on the car has slowly been moving up, until two days ago, I found the brake line touching against the body. 

 

Specifically, the 1971 240z, car is lowered on cut 280z tokico springs with tokico blue struts, with about a 1 finger gap in the rear on 15x7 -0, 215/50/15 with a rear brake disc conversion using a maxima rear caliper. It seems under hard accelertation, the brake line holding bracket is bending up toward the body, am I the only one with this problem? Could some people who have routed their own brakes, or don't have this problem take a picture of the bracket?

Edited April 2, 2013 by seattlejester

[JMortensen]

I had to move my bracket with my early 280ZX setup years ago. I cut the old bracket off the frame and welded it back on a couple inches over and just bent the hard line as I recall.

[seattlejester]

Thanks for the response Jon, I think I may have to consider relocating that bracket as well, either that or cut out the lip that juts out from the unibody.