Jump to content
HybridZ

The turbos I plan to use on my engine swap


Guest 70240z

Recommended Posts

Boy these are huge..

 

Twin Garrett GT30R

Duall Ball Bearing GT30-R Turbo assembly with T3 style housing with T3 inlet flange and 5 bolt style outlet. Specify A/R. T04E style compressor housing with 2.75 - 3.00 inlet and 2"outlet. Good up 400HP mind you thats per turbo. :wink:

 

 

GT30R-225225.jpg

 

2240_Photoshopped-med.jpg

Link to comment
Share on other sites

Guest Zcarsmakemyheadhurt

Thats the ticket buddy, the GT-30Rs have large housing smaller wheels and dual ball bearing....very very quick spool up and your engine is a monster perfect for the street. I get a real good deal on them if you need a supplier. Good luck with that very interesing car.

Link to comment
Share on other sites

You might check out an IHI rx6, supports 3bar(constantly), 600hp/turbo, about the same spool characteristics than my t3. Honda used them on their F1 engines.

I was kinda suprised when I saw a couple of them last week, they're tiny, seem much smaller than the t3 found on the zcars.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...