laurentz Posted October 5, 2004 Share Posted October 5, 2004 I'm very interested in this item! Please keep us updated. Quote Link to comment Share on other sites More sharing options...
Wedge Posted March 20, 2009 Share Posted March 20, 2009 sorry to bring this old thread back up but it may be of use since the Z31 pans are now unobtainable . Were those ever made and sold ? Quote Link to comment Share on other sites More sharing options...
stony Posted March 20, 2009 Share Posted March 20, 2009 yea they were but only to a select few. Nice piece too bad i was on his ♥♥♥♥ list at the time Quote Link to comment Share on other sites More sharing options...
echo006 Posted October 28, 2009 Share Posted October 28, 2009 So, what would be the likelihood that these pans are going to be made again? I would be interested in one, but maybe something that could go in the car as a whole (engine and trans together). Did this pan ever work with the McKinney motor mounts? I read that the clearance is minimal and that the engine had to be mounted appropriately. Quote Link to comment Share on other sites More sharing options...
Evan Purple240zt Posted October 28, 2009 Share Posted October 28, 2009 Ill go ahead and say none, james isn't fabricating anything anymore. Quote Link to comment Share on other sites More sharing options...
ZT-R Posted December 11, 2009 Share Posted December 11, 2009 mckinney motorsports says they have a prototype aluminum pan that they will be releasing/producing sometime in jan 2010ish.. target price somewhere in the 700-800 range. Quote Link to comment Share on other sites More sharing options...
piston Posted February 14, 2010 Share Posted February 14, 2010 can you seriously not just cut up the original one and make a new bottom out of sheet metal and mig the thing up to meet your needs? 800 for a pan is insane. Quote Link to comment Share on other sites More sharing options...
pat1 Posted February 14, 2010 Share Posted February 14, 2010 can you seriously not just cut up the original one and make a new bottom out of sheet metal and mig the thing up to meet your needs? 800 for a pan is insane. You can do that. I have but it doesn't look as good as a full custom pan. Plus no baffles unless you add them. Plus you will warp the hell out of the pan flange if you don't watch the heat when your welding it all up. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.