stprasinz Posted March 25, 2009 Share Posted March 25, 2009 ok lets see here is a list of what I'm doing 95 pathfinder block crank rods and heads 88 stock nissan brand new turbo pistons sealed power rings, main and rod bearings fet mls head gasket hand lapping valves jwt valve springs msa stg 2 turbo cams turbonetics 60-1 liquid to air intercooler methanol injection act clutch fidanza alluminum flywheel pathy intake 60 mm throttle full turbo back 3 inch 2 flow masters one mid saction and one just before the outlet... figuer I can remove the 1st and just run down pipe for drags things Im lacking clutch disc I got an 87 300zx na tranny and the disc that was supposed to fit (also fits 84-86 turbo & 280zx turbo) the engagement is off and it won't slide on the shaft its like it butts up to it???? the stock one is def higher or longer deeper however you want to say that.. I used to be able to find a good disc for 100 now I can't find one???? any idea were there still at?? and I ran a similar setup only cheaper pistons in my 280zx and was running 24 psi until I decided to slap my nitrous kit on it i was golden.... oops but now better fuel management !) Quote Link to comment Share on other sites More sharing options...
260DET Posted March 25, 2009 Share Posted March 25, 2009 Engine management? Quote Link to comment Share on other sites More sharing options...
Careless Posted March 26, 2009 Share Posted March 26, 2009 are you trying to fit a 250mm pressure plate into the transmissions that were made for 240mm ? I don't think you can slide a N/A (FS5W71C) transmission over an 87 turbo pressure plate, as it was for the FS5R30A Transmission. Quote Link to comment Share on other sites More sharing options...
stprasinz Posted March 26, 2009 Author Share Posted March 26, 2009 both are 240mm worked on my 83 280zx turbo t5 tranny and my 84 300zx turbo with a t5 its supposed to work from a 81-83 280zx turbo, 84-87 turbo 300zx, and an 84-89 300zx na.... but apperantly it doesn't work for the na... now Im wondering if anyone knows where I can get a clutch disc that will..... Quote Link to comment Share on other sites More sharing options...
stprasinz Posted March 26, 2009 Author Share Posted March 26, 2009 engine management will be megasquirt fuel and spark direct coil fire boost controller option installed 4 bar map just got a few more things to figure out... like how the trigger angles are set and thats about it then install an tune..... Quote Link to comment Share on other sites More sharing options...
260zturbo Posted April 30, 2009 Share Posted April 30, 2009 i was wondering will a 240mm alum flywheel from a L28turbo fit the w series vg? have a vg turbo with the FS5R30A tranny. i know the pressure plate is 250mm. just making sure the flywheel bolts match up to the vg engine Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.