inlawZ Posted June 8, 2009 Share Posted June 8, 2009 looking for a good condition oil pan for my 240z turbo. my motor is from an 83 zxt but i'm sure any 81-83 turbo oil pan will fit. please let me know price and shipping to 92131. or if you are local So Cal i can most likely pick up. thanks best is to email me at: twista240z at gmail.com Quote Link to comment Share on other sites More sharing options...
inlawZ Posted June 11, 2009 Author Share Posted June 11, 2009 bump Quote Link to comment Share on other sites More sharing options...
2Zowner Posted June 14, 2009 Share Posted June 14, 2009 $200 shipped postal money order or $220 paypal... my email buyaz2@hotmail.com dave Quote Link to comment Share on other sites More sharing options...
wreckedj30 Posted June 23, 2009 Share Posted June 23, 2009 i got one, but lets see if my listing hits, lets say 135$ 155 with shipping. Quote Link to comment Share on other sites More sharing options...
JSM Posted June 23, 2009 Share Posted June 23, 2009 You guys are really getting $125 plus for an oil Pan? Quote Link to comment Share on other sites More sharing options...
2Zowner Posted June 24, 2009 Share Posted June 24, 2009 They are few and far between for the turbo ones...The lowest I'll go is $160 shipped...otherwise I'll keep it and save it for my next Z project...Mine is clean and looks like it has never been used. Quote Link to comment Share on other sites More sharing options...
FlatBlack Posted June 24, 2009 Share Posted June 24, 2009 I had a couple of extra L28 N/A pans sitting around, I tapped the pan and welded on a bung for about $5. If you'd like me to I can PM you some measurements if you want to try it. $200?? Quote Link to comment Share on other sites More sharing options...
rossman Posted June 24, 2009 Share Posted June 24, 2009 Another option is to cut a 7/8 inch hole in the side of the N/A pan (with a step drill bit) and install a AN-10 bulkhead connector (P/N 983210), nut (P/N 992410) and washer (P/N 178014). No welding required. Quote Link to comment Share on other sites More sharing options...
inlawZ Posted June 26, 2009 Author Share Posted June 26, 2009 Thanks guys, i actually picked one up for $40 in great condition Quote Link to comment Share on other sites More sharing options...
FlatBlack Posted June 27, 2009 Share Posted June 27, 2009 From the tranny side of the block, the middle point of my oil return on the turbo is 9 and 3/4 inches from the back edge, and the middle point is 1 3/4" down from that point. This does not take into account the oil pan gasket, my turbo setup is on an L28 with no oil pan on it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.