Jump to content
HybridZ

Leaderboard

Popular Content

Showing content with the highest reputation on 11/01/26 in all areas

  1. Did another motor test fit and added the bell housing to check for clearance. Looks like the oil pan will be a problem. I’m going to try and cut the corner and weld it back at an angle 🤷‍♂️. Everything else was looking good though. I had also wanted to weld this 10AN bung so I could attach the oil primer pump, but didn’t feel like taking the oil pan off, so now that I am, I’ll get this added too.
    1 point
  2. Got the axle situation sorted with some new upgraded shafts. i replaced both sides just incase. and for your viewing pleasure some new england fall foliage shots.
    1 point
  3. Made a notch on the engine mount bracket for the steering shaft, hopefully I can test fit the engine again next weekend. I finished sway bar mounts. Tacked in sleeves for bolts to through bolt it to the frame. Also tacked/welded this angle support for sway bay bar mounts, should be very solid now, I can check that off the list.
    1 point
×
×
  • Create New...