Jump to content


  • Posts

  • Joined

  • Last visited

About Moltar

  • Birthday 10/17/1988

Profile Information

  • Gender
    Not Telling
  • Location
    Sacramento/San Jose, CA

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Moltar's Achievements


Newbie (1/14)



  1. Looking to pick up a hood release cable for an early 240z. Not sure if the other S30 cars will interchange, but I'll take it if they do.
  2. Looking for a 280zx or 280zxt thermostat housing complete with sensors. Shipped to San Jose (95125).
  3. $30 at Autozone plus $10 core. Typical lead time for one of these units is 1 day.
  4. Nice looking Z! How much you pick it up for?
  5. Automobile magazine does a comparison between the new Scion FR-S and a restored 240Z. http://www.ft86club.com/forums/showthread.php?t=15368 Very good read, especially if you have been considering purchasing an FR-S to compliment your Z (like I have been).
  6. What's your email address? I can scan you how I've solved it.
  7. Looking to buy a 4 barrel intake. Would prefer not to spend more than $200 shipped, but that can be negotiable.
  8. This is correct. 1985 was the last year of the straight front axle in their 4x4 pickup. 1986 was IFS, and as a result different calipers. The 86+ calipers were larger than the '79-'85.
  9. 280Z would be a much easier car to swap a V8 in. The manual transmission cars came with R200s, they were fuel injected, and most of the extra weight is in the bumpers. Getting a car factory equipped with an R200 will save you from gathering the parts necessary to swap one in your 240z, and as stated the existing EFI system saves you from getting a fuel injected gas tank and running larger lines.
  10. This is what happens when an engineer has too much free time. Well, I have this yet engine laying around, and I sold the turbo motor from my Z. Wonder what I should do next...
  11. Autodesk has a program out there that will help you solve statics problems. http://itunes.apple.com/us/app/autodesk-forceeffect/id476321600?ls=1&mt=8 Very good stuff.
  12. Exedy had the 240mm Stage 1 organic on clearance on their website last week. http://www.exedyusa.com/garagesale/
  13. What did you use as your power source? Two days seems a bit long. I've done similar work with a car battery charger wand was done after 4-6 hours.
  14. Verify the CC of your combustion chamber on the E88. Some E88s (if from a 1971 Z) actually have the smaller combustion chamber from the E31 head, but have a casting mark for E88.
  • Create New...