Search the Community
Showing results for tags 'Install'.
Found 3 results
-
I have a 1970 240z. I aquired a 1973 240z front bumper that has a different setup/bracket. I do not have the arm/rod brackets for the 73 or the "L" brackets for the 70. What do i need to install it on the 70 z? If i buy the early L brackets will they work or do i need to remove the U shape bracket (that looks like the rear) that is bolted inside the bumper and utilize or drill a new hole on the bumper? If the L bracket will work, i am willing to buy them, but didnt want to until i consulted with someone who is more knowlegeable on the issue. Picture: Early on top, 73 on bottom. I have the bottom and the left bolt seems to line up and so does the hole on the bumper behind the bracket stud according to the picture but i have not done any measuring. NOTE: I will also move the guard to a more outer position since the early z's had the guard next to the light bucket and the 73's had them about 4 inches on each side closer to center. In addition, i will have to find an overider that belongs to the early z. the 73 is a shorter bar and will not work.
-
So I had bought an S30 air dam from Japan this past summer but never got around to mounting them to the car until this past winter. I originally got air dam with turn signal cutouts because I was planning on doing front turn signal swap and going for a 240z set, now I'm not so sure. Anyway, upon install I realized that the air dam doesn't come close to the sitting flush against the mounting points near the headlight buckets. At first, I figured it might be because there's extra material on bottom of the mouth of the air dam but I assume that even after cutting it it still wouldn't sit flush on the mounting surface anyway. Additionally it seems as if the vertical faces on the inside of the turn signal cut outs aren't long enough to sit flush with the inner most edge of the mounting surface. Also when you have one side of the air dam seated flush along the fender lip, the other side is pushed away from it, which leads me to believe that the air dam's overall size is too narrow. Am I wrong in assuming that the 240z and late 280z air dams are similar in nature? I'm very close to just purchasing a fiberglass 280z air dam and redoing it in carbon. Apologies for the lack of light in the photos, I was doing this at about 11 at night.
-
I learned a few tricks when installing my bumpers. ( as requested by California Highway Patrol) I bought some used ones and the rear must have been in a slight accident because the bolt flanges were bent and did not align with the body holes. Tip #1 Hammering then prying the side flanges on the rear bumper back into shape does not work we'll. cut a piece of wood about 1.5" x 1.5" and jam it under the flange. Stand it on its end the hammer it down. Works great. Tip #2 To attach the rear bumper, fasten the straight part to the body first, then attach the side flanges to the body next, then screw the sides to the straight part. Reason - if there is any irregularities, the holes will not align if you try to install the whole thing at once. Tip #3 Use some 1/2" (inside hole dimension) rubber bearings between the body and side flanges of the rear bumper. Gives good spacing.
