Search the Community
Showing results for tags 'bolts'.
-
Hi all, I'm very happy to announce my new business Boltright Automotive Hardware. I've been restoring my 260z for over 10 years now and like many I wasn't exactly careful with the hardware when pulling the car apart. So instead of trying to find the right bolts for the right place and having them re-plated I had a better idea, purchase an original unmodified parts car, measure every single bolt/nut/clip on the vehicle and match it as closely as possible to a new piece. Yes it was painful but it has allowed me to offer the community a near complete full vehicle kit for the S30, with over 2600pcs. The included hardware is as close to OEM as possible, individually labelled for a smooth reassembly process. Nearly all pieces are Japanese made with only a few exceptions here and there. Not needing every bolt? I've got you covered too, you can purchase one section at a time also! Happy Bolting! https://boltright.com.au/#/kit/s30
-
Hey folks trying to take out the drive shaft so i can take out my transmission and engine. been trying to throw a wrench on the nut (at the end) and use a screwdrive to turn the shaft so the bolts can loosen up. how ever this isnt working. tried pb blaster, wd40, wd40 penetrate. next thing ill try is heat but im worried about the grease, oils from earlier and the break lines near by. alternatively im thinking about grinding off the nuts but not sure if there are any other ideas. please lmk! P.S. I started stripping the nut head. https://imgur.com/a/w9CVTiL
-
Size/length/and pitch of the compressor “bracket bolt sizes”?
DUDE posted a topic in Nissan L6 Forum
Does anyone know the size, length ,and pitch of the bolts that hold the bracket for the compressor on in L24 engine? -
I was changing the headlights in my 78 280Z tonight and I managed to snap 3 of the 4 bolts that hold the headlight in (the ones with the flat head). Can someone please tell me the size, length, and pitch of these bolts so I can buy replacements? I also need to get the remaining bolts out. I am thinking pliers, because they protrude on the other side, but would a small easy-out be a better idea? Thanks!
-
I learned a few tricks when installing my bumpers. ( as requested by California Highway Patrol) I bought some used ones and the rear must have been in a slight accident because the bolt flanges were bent and did not align with the body holes. Tip #1 Hammering then prying the side flanges on the rear bumper back into shape does not work we'll. cut a piece of wood about 1.5" x 1.5" and jam it under the flange. Stand it on its end the hammer it down. Works great. Tip #2 To attach the rear bumper, fasten the straight part to the body first, then attach the side flanges to the body next, then screw the sides to the straight part. Reason - if there is any irregularities, the holes will not align if you try to install the whole thing at once. Tip #3 Use some 1/2" (inside hole dimension) rubber bearings between the body and side flanges of the rear bumper. Gives good spacing.