fusion Posted March 31, 2020 Share Posted March 31, 2020 Hello, I cut out the seat bracing in my 76 280z so I could run different seats and put them directly on the floor. I could weld in a 2x2 square tube back in where the forwardmost brace was. I would weld to trans tunnel on one side and the inside of the rocker on the other. Is it worth it? I know these cars benefit from additional bracing but not sure if this area matters. Car has a 5 point roll bar. Thanks Quote Link to comment Share on other sites More sharing options...
LLave Posted March 31, 2020 Share Posted March 31, 2020 I added a piece of tubing that tied in my trans crossmember to the rockers. Stitched it to the floor. Quote Link to comment Share on other sites More sharing options...
grannyknot Posted March 31, 2020 Share Posted March 31, 2020 20 hours ago, fusion said: Hello, I cut out the seat bracing in my 76 280z so I could run different seats and put them directly on the floor. I could weld in a 2x2 square tube back in where the forwardmost brace was. I would weld to trans tunnel on one side and the inside of the rocker on the other. Is it worth it? I know these cars benefit from additional bracing but not sure if this area matters. Car has a 5 point roll bar. Thanks I think it's worth it. Quote Link to comment Share on other sites More sharing options...
fusion Posted April 2, 2020 Author Share Posted April 2, 2020 Thanks for the comments everyone. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.