midnightzxt Posted February 9, 2005 Share Posted February 9, 2005 I have come to the decision to buy an ACT HD PP and Street Modified Disk from a local shop. What else should I replace along with it? So far I know I need to replace the throwout bearing.. what else? Quote Link to comment Share on other sites More sharing options...
Tim240z Posted February 9, 2005 Share Posted February 9, 2005 Have a good look at your hydraulics while you are under there and replace the master/slave if necessary. Also, don't forget the pilot bushing/bearing. Quote Link to comment Share on other sites More sharing options...
JMortensen Posted February 9, 2005 Share Posted February 9, 2005 I believe the ACT stuff comes in a kit with the T/O bearing and pilot bushing, check with your vendor on that. You've got a 50/50 chance that you'll blow the clutch master and slave when you put the heavier plate in there regardless of their condition now so be prepared for that. Quote Link to comment Share on other sites More sharing options...
zcarnut Posted February 9, 2005 Share Posted February 9, 2005 I always like to change the input shaft seal on the tranny. Especially if there is any sign of fluid leakage. Also, don't forget to inspect the friction surface of the flywheel to see if it needs re-surfacing. Quote Link to comment Share on other sites More sharing options...
Guest De Schmaydee Posted February 10, 2005 Share Posted February 10, 2005 ....i'd change rear seals on the engine too...... ......s Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.