toolman

Welded the frame rails to floor pan and rear crossmembers. In the front, rails welded to reinforcement plates attached to floor pan. Rear section was welded to existing rear crossmember. Rails were also spot welded in the middle sections. In preparation for engine compartment rail construction, the engine compartment was boxed to prevent body shifting while cutting off the front rails. The photo shows using the bubble level on the top of the engine to sidewards level. The car must be set level before any cutting can be done.

right side interior floor reinforcement Waiting for magnetic starter switch for my air compressor so I decided to finish the floor reinforcement plates. These 16 gauge steel plates are located inside the vehicle at the bottom end the firewall and front section of each side floor panel. They will reinforce the floor and firewall directly above the frame rails. The plates are about 4 inches wide about a foot long. This should spread the frame load over a wider area of the floor sheet metal. left side interior floor reinforcement

My Z Project has been delayed by a deal that I could not pass up on. One of my customers had a C-Aire 7 1/2 HP two stage compressor with 80 gallon tank. It wasn't running because of a broken inlet valve. The price was $500 so I said "Sure" and load into my truck. Had to wait for couple weeks to get the compressor head rebuilt kit. I spent the time cleaning and checking the parts. The parts came in last week and I reassembled the compressor. Everything is ready to go except the wiring and control devices. Should be only a weeks more before I can get back to my 240Z project!!!

interior reinforcement plate mock up firewall shape guide bottle jack used to trial fit connector rear connector test fit front connector holding jig rear connector holding jig exterior reinforcement plate I was delayed for couple of weeks as my air compressor broke down. As usual. all the necessary parts had to be ordered from the Mainland. Finally got the parts in and compressor fixed. Sure was difficult to work without a air compressor. Hope to get back on track now.