chaos

I got my headlight buckets, great quality. Doing the paint tomorrow with the warmer weather here

Look up KTM, he has the 2 1/16 too, I just bought mine and will be ding the 2 1/16 install shortly myself.

Heh got mine in this morning, they look nice and new....now time to get the car that way, over time

Well lest we all know he is keeping bust with three orders in the same time frame

I got an update early this morning

Looking for 2 clocks still please and thank you

Kinda wish I had the extra coin right now myself to drop on this

Pmed back

Pm have been sent to both

Looking for a in good shape lower hatch lift support...seems mine is hogged out. Also if anyone has a good working rear hatch strut please let me know

Putting in some cipher seats, I'll add some photos after I get my bracket made

I just placed an order a week ago too...and ya kinda slow on responses, need new headlight buckets and flares....if palm had them I would order haha

So I'm looking for broken clocks to gut to put new gauges in for my swap but am gonna try and use the classic bezels so looks stock. If anyone has any for 240z cars please let me know, thank you.

Oooooo me me finally have enough pennies

I can have a dizzy cap made from my machinist, I can show you what he made for me for a reasonable cost. Shoot an email and I can shoot you a few photos oblivions13chaos@aol.com

A full set up on ebay, says they have light scratches and dings, but you may want to look at em they look good but kinda expensive

72' z why I'm looking for the fiberglass

In need of a fiberglass driver side and passanger headlight bucket. Thanks Shoot a email please oblivions13chaos@aol.com

Oops read it wrong

Also thank you six for lest saying It looks alright.

Well first thing I wanted to do was run my crank trigger system that I have Hoke make for me...but I want sequential too, and kinda need a second signal so going with this for a short time till I can commission hoke to make a setup with the second sensor that looks good.

It is yes, I may have it upside down lol. Need to pull it apart again to powder coat.

Ok third try on this post. But I had this cap made for my trigger wheel and CNP/COP setup. So I wanted to test the waters to see is anyone else would like to have these made. Seen them in the past for over 200 each I would have these made for around 150, would take a week or two to be made. Also would need the washer in the dizzy that the rotor attached to be machined down (shown in photo) I had this done for a lower profile. As I said this is a test to see what kind of interest this would gather among the z guys. Thanks for looking.

Stuff looks awesome and I'm not much for CF.

Pmed