Search the Community
Showing results for tags 'lowering'.
Found 4 results
The springs: https://zcardepot.com/products/coil-spring-set-stock-and-lowered-240z-260z-280z?variant=21384265269361 I'm planning on installing new springs and struts and I've found this option. I don't race my car and my suspension is totally stock so far, I feel my springs and struts are fine I'm just looking to lower it. I want a 1.5 or 2" drop, I like that the springs I've linked seem linear and not progressive. They don't give much of a description of who makes these springs or where they come from though. Has anyone used them? Would you recommend them? I like the amount of drop some people get with the Tokico springs but we all know they're discontinued. I don't think I'll go the eibach route because I've been reading that they don't drop the ride height much. Also if anyone's running other brands like vogtland or STAGG etc. let me know what you think about them.
Hey guys, I just started installing my Eibach ProKit springs on my 240z. I brainlessly painted over the part numbers on the springs so I had to do a lot of research to figure out which one was which. The longer non-progressive spring is 6305.001 and goes in the front, I believe, and the progressive shorter spring is 6305.202 and goes in the rear. This is correct yes? I installed the longer non-progressive spring (what I believe to be 6305.001) on one of the front struts last night and the spring looks to be slightly bent out sideways -- i.e. it's not straight up and down. You can also see that it's not straight because the piston rod is not visibly centered within the spring. I'm not sure if it's just not seated properly or what. I did notice the spring coil ends are in the little groves in the strut cap and strut base. See the pictures below and see what you think.
I have found a few threads on this issue, but no real resolution. The front sits noticeably higher (over 1") after the installation... it appears the front didn't even drop a millimeter from stock. Springs: Eibach Lowering Kit Shocks: KYB Checks: 6305.001 springs are on the front. 6305.202 springs are on the rear. The label and part number are right-side up so you can read them. The springs are seated properly. The control arm bolts/nuts were tightened with the load of the car (not on jack stands). Does anyone have a clue as to why the front did not lower? Seems basic enough...
Hi there, I am looking for a set of lowering springs for a 76 datsun 280z. Something that gives me a 1-1.5" drop. Eibach, Tokico etc. If anyone has some for sale or knows of where I can purchase (in stock)...please let me know. Thanks! Rich