Jump to content
HybridZ

kevinz

Members
  • Content count

    47
  • Donations

    0.00 USD 
  • Joined

  • Last visited

  • Feedback

    0%

Community Reputation

0 Neutral

About kevinz

  • Rank
    Moving Up
  • Birthday 11/14/1969

Profile Information

  • Gender
    Male
  • Location
    ft worth tx

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Enable
  1. kevinz

    Wanted: 240z, 260z, or early 280z

    I have a 1975 280z roller. I’m located in Dallas/ft worth tx. I have all the parts for the car except for brake lines, fuel lines, carpet, and headliner. Car had brand new coilovers instslled. New poly bushings installed. New bearings front and rear. Bottom has been painted black. Bad dog frame rails installed. Disk brakes front and rear. LS1/4l60e with computer and harness already cleaned up and flashed. R200 lsd. Headers for swap. Radiator for swap. Engine and trans mounts for swap. Drive shaft for swap. Lots of other parts. I have an f54/p90 block and head also. My bottom dollar with LS drivetrain is 8500.00. If you didn’t want the LS and all of the swap parts then it would be substantially less. Call or text if you’d like. 817-733-4889. Kevin
  2. kevinz

    Want to buy z31 turbo cv axles.

    I have some
  3. kevinz

    280zx turbo intake manifold

    I have one
  4. kevinz

    WTB: Finned R200 Diff Cover

    I have one.
  5. Are you still looking for a project? I have a 75 280z. Minimum rust. I have everything for it except for carpet, headliner, weatherstripping, brake lines and fuel lines. It was going to be an LS1 swap. I have the drivetrain and mounts. Coilovers, disk brakes, bad dog frame rails, roll bar, r200 lsd, lots of parts.
  6. kevinz

    New Possible wheel option

    I know this is an old thread. Does anyone know if mastermind had any issues with rubbing or bottoming out. I know he said he had to roll the rear lip but that's all that was said. Thanks.
  7. kevinz

    Tire width

    Nice car ktm. 16's look really good. It's good to know that you can still hook up pretty good without wider tires and flares. I really hate to cut up my fenders.
  8. Thanks for the info. I didn't do the bearings myself so I can't say for sure if everything is correct. I'm pretty sure somethings not right. There is a definite drag when turning them by hand. I'm going to take them back and have them double check everything.
  9. I meant rear bearings. Auto correct.
  10. One more question. I just replaced all the rest bearings and seals and now it is very tight and hard to turn the hub. Is this normal or do I have a problem
  11. With them in place the bushings stick out a little.
×