Gen I & II Chevy V8 Tech Board

8903 topics in this forum

1. LT1 EFI and ECU

   By antwanray, May 28, 2005
   • 4 replies
   • 1.3k views
   • 
   • wheelman
   • May 29, 2005

3. planing swap

   By Guest richies350Z, May 28, 2005
   • 1 reply
   • 559 views
   • 
   • Tim240z
   • May 29, 2005

4. What do you think about this cam?

   By dr_hunt, May 26, 2005
   • 4 replies
   • 670 views
   • 
   • dr_hunt
   • May 27, 2005

5. LT1 Setback with JTR Mounts

   By 240Z28, March 24, 2004
   • 4 replies
   • 1.2k views
   • 
   • Guest
   • May 25, 2005

6. Need image of JTR mounts installed

   By tkach, May 25, 2005
   • 4 replies
   • 978 views
   • 
   • tkach
   • May 25, 2005

7. 71 Wiring for the fuel pump does not work.

   By Dave, May 24, 2005
   • 6 replies
   • 1k views
   • 
   • Guest
   • May 24, 2005

8. Flywheel size clarification need for t5 transmission

   By Guest nwzeeman, May 23, 2005
   • 3 replies
   • 2.9k views
   • 
   • Kazuya1274
   • May 24, 2005

9. T-56 wiring harness

   By jbeech, May 23, 2005
   • 5 replies
   • 3.1k views
   • 
   • GAZRNR
   • May 24, 2005

10. Ford Question for Chevy Guys. 1 2

    By Guest RunninOnEmpty, May 17, 2005
    • 27 replies
    • 5.5k views
    • 
    • 280zwitha383
    • May 24, 2005

11. gapless rings worth the extra cost??

    By grumpyvette, May 23, 2005
    • 2 replies
    • 1.1k views
    • 
    • dr_hunt
    • May 24, 2005

12. port size vs torque 1 2

    By grumpyvette, April 5, 2005
    • 22 replies
    • 35.2k views
    • 
    • grumpyvette
    • May 23, 2005

13. Pre-motor swap

    By Wide260z, May 23, 2005
    • 1 reply
    • 695 views
    • 
    • hanomon
    • May 23, 2005

14. 94' LT-1 oil press sensor wires location

    By hanomon, May 22, 2005
    • 2 replies
    • 684 views
    • 
    • hanomon
    • May 22, 2005

15. Gas mileage out of your Chev 350?

    By Guest Wes06, May 19, 2005
    • 6 replies
    • 1k views
    • 
    • Guest
    • May 22, 2005

16. Fired the LT1 tonight!!!!! 1 2

    By wheelman, May 18, 2005
    • 24 replies
    • 2k views
    • 
    • azguy
    • May 22, 2005

17. Turbo Camshafts

    By Guest FasterbyFosta, May 17, 2005
    • 3 replies
    • 873 views
    • 
    • grumpyvette
    • May 21, 2005

18. Refreshing an SBC

    By VinhZXT, May 18, 2005
    • 5 replies
    • 909 views
    • 
    • Tim240z
    • May 20, 2005

19. 195 AFR heads/ 50 shot.. engine analyzer pic

    By COZY Z COLE, May 18, 2005
    • 3 replies
    • 915 views
    • 
    • COZY Z COLE
    • May 19, 2005

20. opinions wanted

    By WickedWild, May 18, 2005
    • 8 replies
    • 1k views
    • 
    • Mike kZ
    • May 19, 2005

21. Experience needed for V8 conversion...? 1 2

    By Guest Anonu, May 13, 2005
    • 23 replies
    • 2k views
    • 
    • Guest
    • May 19, 2005

22. drive shaft?

    By Guest turdbo, May 18, 2005
    • 2 replies
    • 707 views
    • 
    • 80LS1T
    • May 18, 2005

23. Small block 280z

    By Guest turdbo, May 17, 2005
    • 3 replies
    • 899 views
    • 
    • BrandonsZ
    • May 18, 2005

24. Sand in the engine....

    By 240playtoy, May 16, 2005
    • 8 replies
    • 1.5k views
    • 
    • jbk240z
    • May 18, 2005

25. Well guys, it's official. It's 260 time!

    By Guest 305240, May 17, 2005
    • 3 replies
    • 833 views
    • 
    • Guest
    • May 18, 2005

26. Fluid damper Question

    By Guest 007fastZ, May 10, 2005
    • 7 replies
    • 1.5k views
    • 
    • Psykovertible
    • May 17, 2005