Jump to content


  • Content Count

  • Donations

    40.00 USD 
  • Joined

  • Last visited

  • Days Won

  • Feedback


240zip last won the day on January 21 2010

240zip had the most liked content!

Community Reputation

11 Good

About 240zip

  • Rank
    Junior Member

Profile Information

  • Gender
    Not Telling
  • Location
    Northern Colorado

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I'm replacing the OEM harmonic balancer. The ATI makes a couple of different harmonic balancers (different weights, different diameters) http://www.atiracing.com/products/dampers/charts/damnissan.htm 917801 is 5.45lbs and 7.074" diameter 918040 is 3.9lbs and 6.325" diameter This is for a L28ET build. We're going to be using a SDS (Simple Digital Systems EMS) with crank ignition. So magnets will be added to the balancer. Any recommendation on which balancer to go with? Should we forego the ATI altogether?
  2. We did an install of the Wizard Cooling Performance Radiator into our 240Z. 2.9L (overbored 2.8L) with E31 head and flat top pistons. Nice construction. https://wizardcooling.com/1970-1973-datsun-240z-aluminum-radiator/
  3. Has anyone used the above Tach Adapter with SDS? I have the EM5-6F (from SDS) for 240Z turbo swap.
  4. I'd really like to see a RetroSET LED installation on a 240Z. I saw that some modifications were necessary to the housing.
  5. I"m going to assume these are for the 2.8L block. I just got a set of forged pistons (custom made) for a 2.8L turbo build up. These are clearly for a high-compression NA motor. The final compression will depend on the head selected, whether or not that head's been shaved, head gasket, etc. Lots of variables. This would be a good start for a great NA (triple Weber) motor.
  6. Jim, did you end up selling out on this production run? Does anyone make these shortened CV shafts?
  7. I know it's been a few years since you posted. Do you still have a set for sale?
  8. 240zip

    R200 CLSD

    I was torn between the R200CLSD and the R180 LSD conversion from a WRX STi. For my set-up ... a 240Z with a 2.8L (E31 & flat tops) and triple webers ... the R180 route was the way to go. It was easier and lighter. I used John Coffey's stub axles and it was a simple bolt in. If I look at the cost of the cost of the R180, the stub axles, and the cost of rebuilding the 1/2 axles professionally ... it was about $1,000. So the R200 at $1000 on eBay seems like a decent deal. The R180 I have was 3.7 as well. If I were building a higher output turbo motor set-up ... I'd consider the R200 and also go with a CV conversion.
  9. When putting a L28ET into a 240Z chassis - does the new (swapped) engine use a cable throttle or does it use the old bell-crank rod and linkage setup?
  10. Thanks for the heads up on the eBay link. I went and immediately got a pair.
  11. Tried to PM him to get that price. Looks like you got a special deal.
  12. I ended up going with the non-vented hood. I now have an OEM NOS 280Z hood that's going to be sold off. Hopefully someone in the Colorado area can use one. I don't want to ship this.
  • Create New...