abes

You still interested?

Ok- let me know. Thanks

Just sent you some pics. Thanks.

Hey- I've got a set of Rick wong rb mounts that I'm probably not going to use as well as a new rb20 oil pan and modified strainer that have been modified for the rb26. Let me know if your interested. Aflaytes@hotmail.com Thanks

Ive got a set of 2 piece work ewing iii that I might be selling. I was going to redo them but haven't gotten around to it yet. They're staggered set but can't remember the specs at the moment, i want to say 16x8 and 16x9. I took them apart to send out for polishing and re-paint but never got around to doing it. The pic with them in silver is how the centers look now after stripping the paint but they've been taken apart. The pics with them in purple is how they looked when I first bought them.

For what car??

Are you looking for a s30 or s130?

Yea I know, just looking are used one- little cheaper. Thanks..

Good to know- thanks..

I'm looking for the flange / Attachtment end from a steering shaft off a 240z See attached picture. Please let m know if you have one. Thanks..

Looking for an aluminum fuel rail (pale type) for 10.5mm o-ringed injectors. Thanks

I checked the cable but it frozen- no good. Sorry bout that..

no prob- issue is that they have tires on them so I have someone unmount them. i can do it for $50 plus shipping but it may rise the shipping cost a bit.

Ok, I have 2 wheels avail, no center caps though. $65/pc + shipping. Let me know, Thanks..

Just found one- no longer need..

I might have one. I'll have to check tomorrow

I might have a pair for sale but won't know till the weekend.

Great, thanks for your help.. I edited the original post.

I'm looking for a CAS optical chopper wheel from any of the following: - VG30e(t) from either a Z-31 300zx or a maxima - (F31) Infinity M30 Please let me know if you have one for sale via email or PM. aflaytes@hotmail.com Thank you..

No, axles were marked prior to removal. I shaved those little burrs that were on the axles (pictured above) down with a dremel and cleaned/ greased it well and it slid into place. Thanks for your help...

There's about 3/8" left for it to be fully inserted. I don't have any pics at the moment but everything seemed ok. I was able to move the c clip a bit and center it but it dis t help..

Don't know what exactly its from but i do remember that when I removed this side it was a bitch..

Just tried that- no luck I did see these marks on the axle though, your thoughts?

I need some help.. I just swapped my r200 LSD from one car (83 turbo) to another (83 turbo) and put the standard turbo r200 into the other car. I've done this swap at lead 3 times in prior years and am now having issues with the stub axle. Both the left and right axles are from the same exact diffs, each one going back to their pertain diff. I just needed to remove them to get the diff out of the car. Left is back side is on the left and right is back on the right side as removed. The issue I'm have is that the right side (passenger) axle is not going all the way into the diff. I did the left side and had no issues (clipped in) but the right won't go all the way in. Ive tried tapping it into place with a hammer but its not budging. Ive even inserted it to the wheel side stub (not yet screwed) to help me put a bit more pressure toward the inside but no luck.. I've been at it for an hour and Im stumped..

Thanks but it needs to be for a 280zx. The fujitsubo is for the z's..