72240Z
-
Posts
45 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Events
Gallery
Downloads
Store
Everything posted by 72240Z
-
From the album: Z Parts
-
One more picture of the key marks.
-
I cleaned it up. It's not perfect but it looks good.
-
I don't know if the 240 cover will fit but I have the 48470-N3600 cover if you need it. It's dirty from storage.
-
I have the parts you want but the shipping might make the cost to high, can't you find those parts in the UK?
-
Do you need an early cam that uses a spray bar or a later cam that oils through the cam? I have an early one from a 240 ,the 280 cam from LanceVance should be The one on top is a late cam. The one on bottom is a early cam.
-
You need that part from a 70 to 73 after that they changed. A good body shop should be able to fix the part you have.
-
PM ed you about the rods you are looking for.
-
More pictures for Z-Rider
-
Round top
-
I have one of a 73 240 with a little surface rust. What do you consider cheap?It's in Asheboro NC 27203 so shipping might be high unless you know a cheap method.
-
If I were you I would pound it out with a body hammer. But if you want that piece I have a 73 240 I can cut it off, if you will draw a line around where you want it cut I will make sure the piece I have is good $25 plus shipping from Asheboro NC 27203
-
That's good to know. Thanks for the reply.
-
73 4speed whole trans
-
would the plug from a 240 work? I may have one I will have to look tomorrow.
-
What do you consider priced right? And could you pick it up in North Carolina?I know it's farther than you want to drive.
-
I have one in an old rusty hatch I'm in Asheboro NC it is 154 miles from Shaw AFB if you are interested in it you can message me
-
zboi I sent you a private message.
-
Do you need the whole strut? It sounds like you may need the A arm too.It's to wet today but I think Saturday is going to be nice. If you want to pull the parts I will let you have the strut the A arm and the axle for $65
-
I have a 73 240 in Asheboro NC. Did you take the spindle lock bolt out?
-
No longer available. I didn't hear from you and I cut it in two when I cut the roof off.
-
I can cut that part off a 73 I have if you still need it. $35 plus shipping from North Carolina 27203.
-
I have a 1973 parts car. If you think they are the same I will go check to see if it is ok. If it is ok I will take $25 + shipping. I am in North Carolina
-
You may still need the curved crossmember because your 1970 Z has the rear mounted further forward. If you still need one I have one.
-
darom if you used Strong Arm part #4313 it is for a 240Z that only has 1 strut and is to strong for a 280 with 2 struts. The post above you had a different part # for the 280.
