Search the Community
Showing results for tags 'dcoe'.
-
I have been having so many issues tuning my triple OER/SK dcoe 40 carbs. I recently bought these carbs secondhand. I have been running into issues with idle speed, and synchronizing. The car runs very rough and the engine shakes quite a bit. Problem #1 I attempted to synchronize all three of the carbs but ran into many issues. The carb (#2) in the middle seems to be drawing in a lot of air compared to the carb (#1) and carb (#3). This is with all the carbs set to the same idle speed screw distances. I suspect that carb #2 has a bent throttle shaft or butterfly, but the butterfly ope
-
Has anyone ever used the EMPI HPMX carburetors on a Datsun before? I tried to do some searching and couldn't find much of anything? http://vwcatalog.empius.com/vwcatalog/2014/60.html https://www.youtube.com/user/EMPIHPMX/feed They are mostly used on VW air cooled engines, but I don't see why you couldn't just bolt them right up. They have a few videos showing dyno results where they made a few more HP than there Weber equivalents.
- 4 replies
-
- dcoe
- carburetor
-
(and 1 more)
Tagged with:
-
Found what I was looking for. Thanks everyone. Moderators, I wish to close this thread.
-
Anyone ever seen something like this? Its off a 48/45 DCOE Weber on a race build 3.1L setup. Was this an OEM part or something custom fabricated after the fact? Any known history?
-
Doing a slow restore on a 72 240 i picked up. Weber 45s were having some trouble sneezing and leaking so took them off to clean em up and replace gaskets, set floats etc. Noticed these adjustment screws which i find no mention of in Haynes manual, or any online reference ive found. These are the later 152s with nitrophyl/spansil floats so im thinking it was a modification on later models? has a white plastic hat/cover. one on each throat. with plastic cover removed needle screw with fastener nut needle pokes through main venturu/choke into carb throat (uppe
-
Hello, recently i just recently purchased a used set of weber 40 dcoe. But basically i am missing a few parts such as the three eye joints that screw on to the manifold, and one butterfly and throttle shaft. What had happened was i bought the set of webers that had the three pieces of linkage missing so i new i was going to need those. But me being an idiot i was disassembling the first carb without penetrating fluid so i stripped the heads of the screws that hold the butterfly and the throttle shaft in place and i had to drill out the holes. But the throttle shaft needed to be replaced anywa
-
Hello hybrid z I have a question regarding the triple weber carb kit that is for L series engines. Well i am planning on getting the carb kit but i'm not sure which one to get. Here is a video of my car specs on the engine are in the description. Not sure what cam but here is what i think it is Grind: 17036. Lift(In/Ex): .495/.495. Duration(In/Ex): 290/290 any thoughts on this.