MegaSquirt

2001 topics in this forum

1. Way to check Megasquirt when buying used?

   By dpuma8, October 7, 2011
   • 1 reply
   • 1.1k views
   • 
   • dexter72
   • October 7, 2011

3. few setup questions

   By stprasinz, February 15, 2008
   • 3 replies
   • 1.1k views
   • 
   • dexter72
   • February 18, 2008

4. ms2 pcb testing-found curious electrical readings

   By macambra, January 8, 2012
   • 1 reply
   • 1.1k views
   • 
   • macambra
   • January 11, 2012

5. pullup voltage confusion

   By trwebb26, August 30, 2006
   • 4 replies
   • 1.1k views
   • 
   • trwebb26
   • September 3, 2006

6. v3.57 IGBT High Current Ignition Coil Driver Issue

   By TooSlowToCare, June 16, 2009
   • 0 replies
   • 1.1k views
   • 
   • TooSlowToCare
   • June 16, 2009

7. I think I burnt something on my MS board

   By zane9000, March 30, 2006
   • 4 replies
   • 1.1k views
   • 
   • BLOZ UP
   • April 1, 2006

8. Occasional rough running when cold - Have to reset MS

   By TrumpetRhapsody, December 4, 2008
   • 6 replies
   • 1.1k views
   • 
   • TrumpetRhapsody
   • December 7, 2008

9. Ok so it is all hooked up but....

   By Guest Stingray280zx, May 28, 2005
   • 3 replies
   • 1.1k views
   • 
   • onephatz
   • June 1, 2005

10. Finally runs like beast

    By kvansic162, June 17, 2007
    • 4 replies
    • 1.1k views
    • 
    • randy 77zt
    • June 19, 2007

11. Another V3+MSnSE vs MSII thread...

    By BLOZ UP, May 13, 2006
    • 3 replies
    • 1.1k views
    • 
    • BLOZ UP
    • May 15, 2006

12. MSnS V2.2 identification

    By Nizm0Zed, December 20, 2008
    • 2 replies
    • 1.1k views
    • 
    • mobythevan
    • December 22, 2008

13. Rebuilding a Turbo for Ms...

    By badjuju, October 21, 2005
    • 3 replies
    • 1.1k views
    • 
    • badjuju
    • October 25, 2005

14. question on wiring megasquirt...

    By Mack, April 10, 2006
    • 2 replies
    • 1.1k views
    • 
    • Mack
    • April 10, 2006

15. Took the z to the track

    By Z_Dust, May 17, 2007
    • 3 replies
    • 1.1k views
    • 
    • Z_Dust
    • May 18, 2007

16. Electronic Boost Control (Change wiring to use MS Relay Board) Which terminal?

    By LiquidCMR, May 31, 2017
    • 1 reply
    • 1.1k views
    • 
    • LiquidCMR
    • May 31, 2017

17. LS1 tach signal bouncing

    By mobythevan, August 6, 2007
    • 0 replies
    • 1.1k views
    • 
    • mobythevan
    • August 6, 2007

18. Corrupting Firmware...possible problem

    By cygnusx1, August 26, 2007
    • 0 replies
    • 1.1k views
    • 
    • cygnusx1
    • August 26, 2007

19. MS-I V2.2 board reliability

    By mobythevan, April 5, 2007
    • 2 replies
    • 1.1k views
    • 
    • mobythevan
    • April 23, 2007

20. Sensors for Megasquirt

    By jacob80, September 11, 2008
    • 1 reply
    • 1.1k views
    • 
    • Guest
    • September 12, 2008

21. Replacing injectors

    By woldson, March 18, 2007
    • 4 replies
    • 1.1k views
    • 
    • woldson
    • March 19, 2007

22. Please post .jpg of enrichments table

    By jrd, April 19, 2007
    • 1 reply
    • 1.1k views
    • 
    • naviathan
    • July 10, 2007

23. RB 25 Megasquirt

    By Billy Ryan, March 7, 2006
    • 2 replies
    • 1.1k views
    • 
    • Billy Ryan
    • March 8, 2006

24. Switched 12V Q. on relay board

    By 24OZ, October 16, 2007
    • 2 replies
    • 1.1k views
    • 
    • 24OZ
    • October 16, 2007

25. MS1-E to MS2-E

    By HB280ZT, February 1, 2008
    • 3 replies
    • 1.1k views
    • 
    • HB280ZT
    • February 2, 2008

26. stock TPS ?

    By GOTHALOSISM, March 1, 2009
    • 4 replies
    • 1.1k views
    • 
    • GOTHALOSISM
    • March 2, 2009