nix240z

If any one has a early 240z 4 speed 70-71 transmission tail section that they would like to sell let me know. or even just the shifter linkage part. It very easy to remove the tail section I had a transmission shipped and they broke off the shifter part.

metal or plastic clips? early series 1 cars have plastic and later cars have metal.

found and purchased, thanks Litman

pm back

Looking for early style 70-71 shifter. like this. thanks steve

Does the Stock fuel rail have a smaller return line? looks like your new set up has the same size feed and return line. Hard to tell from the pictures.

Nice find.. I replaced my roof also which had a sunroof. Steve

Here is a Rebello built 3.2L for comparison.

Check out the link below, they also have a forum. http://www.autobodystore.com/

Choke and hand throttle assembly finished.

I just picked up a Brand new factory dash that had never been opened in original packaging, even had to break the sealing tape. A rare find I must say, and it was less than 10 miles from my house.

This is exactly the way I replaced my roof skin.

make sure you get the screws also, some types of Door lock mechanisms come with longer and shorter screws. Steve

Making rubber parts has slowed down the work on the car but I do have more rubber parts made and installed on the car. I am also offering custom 240z brake and fuel lines with custom insulators for a 5/16" return fuel line, same size as main fuel line. check site of other new items. www.240zrubberparts.com New Clutch pedal stopper on firewall. Wiper motor bracket rubber bushings. Radiator support wire pass through insulators. Door lock mechanism rubber pieces. Euro Tail lights Reproduction slot blank tape and correct 71 choke handle. refurbished the fuel sending/pump harness with new grommet.

If case you need a replacement inner ring for the horn pad I have them. http://www.240zrubberparts.com/apps/webstore/products/show/4432194 steve

looking for a set of 240z front turn signal harness/wires. let me know what you have. Steve

I ordered a new set from my local Nissan last year and they came from the warehouse, dont know if still available or not.

not sure if the same as the 240z knobs but let me know, I have some with blemishes that are not seen once installed at a much lower price. http://www.240zrubberparts.com/apps/webstore/products/show/4425143 steve

These are the boot kits for 280zx turbo Beck Arnley 103-2282 CV Joint Boot Kit Beck Arnley 103-2280 CV Joint Boot Kit http://forums.hybridz.org/topic/64014-280zx-turbo-cv-boot-replacement-56k-beware/?p=1063110

reproduced the early style 70-71 choke cable grommet.

reproduced the Arizona Z Car rear control arm bushing, which are a hard rigid plastic type, with a shore hardness 90A urethane.

reproduced the 70'-71' gas door latch seal.

Thanks... yes, all the items I have reproduced are available for purchase... Steve

All in the tiny details at this point in my build. I have replaced all 40+ rubber tabs that hold the wires to the body. I had to reweld a few tabs that broke off while moving the tabs. Welding after Paint so I had to be very careful while doing this. I could not stand looking at the yellow/worn out defrost wire boot, so I molded my own in clear and also a black version. I went with the clear version, just like the original. The one on the bottom is the original and above are my reproductions.

it can even be broken into piece that I can put back together. Steve