Delasangre4231
-
Posts
263 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Events
Gallery
Downloads
Store
Everything posted by Delasangre4231
-
Thank you. Now I will go look under my dash. Nice pic BTW for an under dash shot.
-
Ok great, stop being so vague. In the link you posted I see a ton of actuators, the picture is hard to make sense of.
-
Removing wheel paint
Delasangre4231 replied to Delasangre4231's topic in Brakes, Wheels, Suspension and Chassis
The paint is over the chrome too! -
If I were to buy a set of wheels that have paint on them how could I go about removal without damage to the chrome lip?
-
Ok, I see the hoses, but where is the vacuum control valve I should replace?
-
Ok but I don't know what parts are in there so which ones specifically are in need of replacement?
-
That comes in the clutch kit.
-
Alright, sounds good. Anything else I should be worried about when changing the trans? I got the clutch, clutch slave, clutch hose, new starter, new fluid, new shift knob, resurfaced flywheel and alot of time...
-
Is there a gasket that goes between the bellhousing and the block?
-
I'm about ready to replace my heater core and everyone seems to want me to change out all the hoses and some kind of control valve too. What are the specifics on these parts and where can I get them for cheap?
-
How much clutch fluid will I need to completely drain and re-fill, what is the capacity?
-
I am going to use Amsoil.
-
How do you get the plug back in then? Unless your pulling the side plug...
-
I know that I was able to pour fluid in the top through the shifter hole when we were doing my friends Nissan pickup trans, but I am not to sure how to do it with this one. I will unwrap the new one in a few days and look. I'm only concerned because if I switch all this out in my driveway and the only way to fill the trans is a pump then I don't know how I will get to a shop.
-
I am about to replace my tranny on my 84 turbo with a new one and have a question. When I am going to put in the new one do I put new fluid in and then put it in or do I install everything and then put fluid in? If the latter how does the fluid go in without some kind of pump. Do I pour it in via the shifter hole and put my finger in the side hole to see the level? Isn't it supposed to be right at the side drain hole when its level?
-
-
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
From the album: 1984 Nissan 300zx
-
I have been tempted to go with the MOMO Super Indy mahogany steering wheel I had in my 280zx but I think I want something different in my 300zx. I hate all the stock 300zx wheels and I am not too fond of that generic racing wheel look so show me what you guys have!