Jump to content
HybridZ
Miles

CARBOTECH AX6 PADS FOR TOYOTA & 240SX CALIPERS

Recommended Posts

Ref: 1972 240Z  daily driver

 

Brake setup:

 

  • Front:  1979 Toyota 4x4 pickup  Calipers on solid 240z stock rotors
  • Rear:   1989 240SX calipers on 300zx non-turbo rotors
  • Master cylinder: 1979 15/16 280ZX
  • Booster: 1977 280Z

 

Since installing this brake system in 2009 I have been experimenting with brake pads:

 

  • Porterfield R4S:  Poor cold bite in traffic. Removed after  about six months to try Hawk Blues.
  • Hawk Blues:  Poor bite at all temperatures.  Removed after about one month to try Axxis ULT
  • Axxis/PBR ULT Ceramic:  Good cold bite on first stop and in traffic. Ok in traffic and mountain driving. 
  • Carbotech AX6: Excellent cold bite and bite gets better with each stop. After about four stops these pads grab hard.

 

Carbotech AX6 pads:  Very little pressure on the brake pedal is required with this brake setup. I have smoked the fronts and the car hauls down fast without a hint of brake fade after several hard stops.

 

At this point I am leaving the Carbotech pads on.

 

Contact Carbotech to purchase pads:  Ask for club 5% discount.

 

  • 1979 Toyota 4x4 pickup:  CT137-AX6  $141.00
  • 1989 240SX: CT272-AX6 131.00

 

 

Edited by Miles
changed master cylinder

Share this post


Link to post
Share on other sites

How has the rotor life been? Has any of the pads used cause you observable increased wear on the rotor due to harder compound?

 

Cool to know there are other options then just the parts store availability.

 

Installed the pads about three weeks ago so can't advise on rotor wear yet.

Share this post


Link to post
Share on other sites

Update

 

  • Dust (least important) was heavy until the pads fully bedded in. Not much dust now.
  • Cold bite excellent
  • Grab gets better as the pads heat up
  • Abused the pads until the fronts were smoking. No hint of fade.

 

Share this post


Link to post
Share on other sites

Carbotech XP10's are great on the race Z, not hard on rotors either. I could buy pads like Project Mu's locally but instead go to the extra expense of importing the XP10's, good people to deal with too.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×