Ignition and Electrical

2694 topics in this forum

1. Brass rotor and cap

   By 280SLY, November 21, 2013
   • 7 replies
   • 1.3k views
   • 
   • NewZed
   • December 24, 2013

3. My first ever project car...and i seek advice (s130)

   By the_lettuce, November 20, 2013
   • 3 replies
   • 967 views
   • 
   • ISPKI
   • November 21, 2013

4. 77 280z EFI relay replacement

   By ISPKI, November 20, 2013
   • 0 replies
   • 1k views
   • 
   • ISPKI
   • November 20, 2013

5. Mid throttle "power" loss.

   By IncompetentOne, November 18, 2013
   • 0 replies
   • 645 views
   • 
   • IncompetentOne
   • November 18, 2013

6. no power to ecu 83 na

   By Turbo72-240, November 12, 2013
   • 14 replies
   • 1.3k views
   • 
   • Turbo72-240
   • November 15, 2013

7. early 260z headlight dim plus related Q's.

   By brianZortiz, November 7, 2013
   • 2 replies
   • 1k views
   • 
   • brianZortiz
   • November 20, 2013

8. 240Z to 280ZX alternator swap charging voltage

   By Sweetpoison240z, October 29, 2013
   • 1 reply
   • 889 views
   • 
   • mattb3562
   • November 2, 2013

9. 77 280z cannot start, injectors not functioning? 1 2 3

   By ISPKI, October 26, 2013
   • 53 replies
   • 7.7k views
   • 
   • nismosilvia
   • December 30, 2013

10. Z31 ecu install Hard/no start after shut off

    By tooquick260, October 24, 2013
    • 9 replies
    • 1.6k views
    • 
    • tooquick260
    • November 5, 2013

11. Wiring from scratch.

    By jkgts1, October 23, 2013
    • 5 replies
    • 1.6k views
    • 
    • jkgts1
    • October 25, 2013

12. Lose All Electricity on Low RPM Acceleration and Turns

    By inZane 240, October 20, 2013
    • 3 replies
    • 1.1k views
    • 
    • inZane 240
    • October 25, 2013

13. Fuse size for injector wires from BAT

    By ISPKI, October 15, 2013
    • 1 reply
    • 946 views
    • 
    • jeffp
    • November 23, 2013

14. Battery Disconnect Switch

    By RebekahsZ, October 11, 2013
    • 5 replies
    • 1.7k views
    • 
    • ritrebor
    • October 11, 2013

15. Pertronix Ignition coil testing

    By ISPKI, October 8, 2013
    • 7 replies
    • 6.9k views
    • 
    • ISPKI
    • October 13, 2013

16. can someone identify this part?

    By Rubenonamission, October 8, 2013
    • 2 replies
    • 926 views
    • 
    • Rubenonamission
    • October 10, 2013

17. Frame Rail/Alternator Ground

    By DuoWing, October 4, 2013
    • 0 replies
    • 905 views
    • 
    • DuoWing
    • October 4, 2013

18. Fuse Block/Wiring Suggestions?

    By DuoWing, September 30, 2013
    • 7 replies
    • 1.7k views
    • 
    • DuoWing
    • October 16, 2013

19. Points to ZX Distributor Conversion Plate

    By SlowRob, September 30, 2013   

    • points
    • distributor
    • (and 2 more)

      Tagged with:

      • points
      • distributor
      • dizzy
      • zx
    • 0 replies
    • 1.7k views
    • 
    • SlowRob
    • September 30, 2013

20. Voltage Regulation Issues

    By ammorri2, September 22, 2013   

    • Voltage Regulator Jumping
    • 4 replies
    • 1.5k views
    • 
    • SlowRob
    • October 1, 2013

21. 240z Wiring Question

    By fallenone121, September 16, 2013
    • 4 replies
    • 1.4k views
    • 
    • ilovemyzed
    • September 17, 2013

22. 73 240z Aftermarket fuel pump and starter wiring.

    By mr_han_solo, September 14, 2013
    • 0 replies
    • 2.1k views
    • 
    • mr_han_solo
    • September 14, 2013

23. Can someone identify these wires? 73 a/t 240z

    By Wilson_WWSC, September 3, 2013
    • 0 replies
    • 875 views
    • 
    • Wilson_WWSC
    • September 3, 2013

24. engine compartment relay bracket

    By alexx933, September 2, 2013
    • 12 replies
    • 1.7k views
    • 
    • alexx933
    • September 5, 2013

25. Green light on ecu stays on and no spark

    By Co0ke, September 1, 2013
    • 0 replies
    • 657 views
    • 
    • Co0ke
    • September 1, 2013

26. Car won't start, it's like the battery is dying, but it tests 100%

    By 1vicissitude, August 30, 2013
    • 6 replies
    • 3.6k views
    • 
    • 1vicissitude
    • September 3, 2013