Gen III & IV Chevy V8Z Tech Board

2187 topics in this forum

1. Fuel for LS2

   By neverenough, May 26, 2011
   • 0 replies
   • 1k views
   • 
   • neverenough
   • May 26, 2011

3. introduction. . .

   By brucevilanch, May 24, 2011
   • 0 replies
   • 64 views
   • 
   • brucevilanch
   • May 24, 2011

4. Adjustable Fuel Pressure Regulator

   By milesz, May 21, 2011
   • 3 replies
   • 2.3k views
   • 
   • RB30X
   • May 22, 2011

5. Drive shaft bolts for JCI driveshaft

   By RebekahsZ, April 17, 2011
   • 10 replies
   • 4.4k views
   • 
   • RebekahsZ
   • May 16, 2011

6. Gas pedal won't fully open throttle

   By Stephonovich, May 6, 2011
   • 4 replies
   • 3k views
   • 
   • Stephonovich
   • May 14, 2011

7. Walbro 255 Fuel pump very loud! 1 2

   By kj280z, April 7, 2011
   • 23 replies
   • 20.8k views
   • 
   • kj280z
   • May 13, 2011

8. Radiator Fan Problems

   By jeff81, March 27, 2011
   • 5 replies
   • 1.9k views
   • 
   • zdlite
   • May 12, 2011

9. Turbo LM7 72 240z: The Quest for Power!

   By badboyz31, March 21, 2011
   • 12 replies
   • 3.8k views
   • 
   • badboyz31
   • May 12, 2011

10. LS1 Alternator Bolts to Belt Clearance Issues

    By SUNNY Z, May 2, 2011
    • 10 replies
    • 3.9k views
    • 
    • zgeezer
    • May 12, 2011

11. Holley LS engine swap pans

    By David K, May 7, 2011
    • 0 replies
    • 1.1k views
    • 
    • David K
    • May 7, 2011

12. JCI LS1 mounts compatibility with LS1 exhaust manifolds

    By zgeezer, April 6, 2011
    • 3 replies
    • 2.2k views
    • 
    • Phantom
    • May 7, 2011

13. Strengthening floor pan around gearbox mount - too much flex

    By RB30X, April 30, 2011
    • 3 replies
    • 2.4k views
    • 
    • RB30X
    • May 6, 2011

14. 32 valve LS heads

    By mutantZ, April 22, 2011
    • 2 replies
    • 1.4k views
    • 
    • SUNNY Z
    • April 26, 2011

15. Need recommendation on serpentine belt

    By RebekahsZ, December 13, 2010
    • 9 replies
    • 2.2k views
    • 
    • mistafosta
    • April 22, 2011

16. 280Z Stub Axles failures

    By alainburon, April 13, 2011
    • 19 replies
    • 4.1k views
    • 
    • alainburon
    • April 18, 2011

17. out with the old in with the new 1 2

    By 240zRacer, December 10, 2010
    • 21 replies
    • 6.4k views
    • 
    • RebekahsZ
    • April 13, 2011

18. 280Z fuel gauge with aftermarket sender

    By alainburon, April 1, 2011
    • 0 replies
    • 1k views
    • 
    • alainburon
    • April 1, 2011

19. Which Tilton 7/8 master clutch ?

    By smoorenc, January 7, 2011
    • 7 replies
    • 4.3k views
    • 
    • EvilC
    • March 31, 2011

20. I've switched to the dark side 1 2

    By lowdown, May 17, 2010
    • 24 replies
    • 4.8k views
    • 
    • Cable
    • March 29, 2011

21. 75 280z + ls1

    By Custom, March 5, 2006
    • 8 replies
    • 2.4k views
    • 
    • alainburon
    • March 28, 2011

22. Heat from LS1 in S30 engine bay

    By RB30X, January 13, 2011
    • 10 replies
    • 2.9k views
    • 
    • Pyro
    • March 28, 2011

23. 260Z / 2001 lS1 T56 Clutch Master

    By Michael1971, April 18, 2006
    • 4 replies
    • 1.8k views
    • 
    • Dunlop
    • March 24, 2011

24. LSx Exhaust Header flange, for custom building headers.

    By BRAAP, July 24, 2009
    • 5 replies
    • 2.4k views
    • 
    • Cable
    • March 24, 2011

25. Water temp sending unit / LS LQ4

    By Dans toy, March 19, 2011
    • 5 replies
    • 2.1k views
    • 
    • Dans toy
    • March 23, 2011

26. LS Article in HotRod mag.

    By cygnusx1, March 9, 2011
    • 5 replies
    • 2.1k views
    • 
    • badboyz31
    • March 22, 2011