Search the Community
Showing results for tags 'Window'.
Found 10 results
-
So...I noticed today that Black Dragon doesn't sell this, nor can I find it on ebay. Know what I'm talking about? The rubber that slides across the window when you roll it down. It's stapled to the chrome pieces at the top of each door. Where can I get these. Maybe I can salvage one with some baseball glove oil and the oven...but my other one is broken. What are you guys doing to replace these? -
Hi, had my driver side glass shatter on me today and am having some trouble sourcing a new one. If anyone has one they’d like to sell or have a parts car they could pull off of for me to buy that’d be great. Also not sure exactly which years of glass will fit in my 75, I know there were changes throughout the years of the car but I read some conflicting things so far. If any well knowing Z guys can chime and help me out with that I’d appreciate it. Thanks!
-
My late 74 260z window regulators are garbage i want to find a good used set somewhere online but i dont know if ony a certain few years will fit or if myabe all 280z omes will fit. Lemme know thanks -
Hello all, I'm in search of two alignment guides that are missing from my 240z. Any help/leads on these is appreciated. The pic is not mine.
-
Hi everyone, I'm looking for the driver's side window glass for a 1978 280z. Anyone have something for sale? Thanks! Luke Austin, TX
-
So I've got a couple other threads about Printing car parts on my 3d printer. Well on my 300zx, the upper window pin again broke yesterday. This allows air to whistle while driving and water to leak in with the rain. I'm tired of tearing the door apare to fix a cheaply made part. So, I started looking into what can be done to fix this issue. Well the stock pin has a white plastic ring around a metal ball end, allowing for some movement. The plastic is what breaks. I looked at it and figures a 5/16" washer would almost fit over the ball portion, but would not fit past it. That woudl be enough to hold the pin in place, but I'm not certain if it required much more than that to keep it from rattling or wearing badly. I got into PTC Creo and desiged a new round bottom portion which would allow the pin to slide in the track AND incorporate the 5/16" washer. I printed it up on my Mendel Prusa 3d printer at .1mm layer height, and a .5mm nozzle. at 80% infill. This created a very strong part with a little xacto persuasion I was able to fit the stock metal door pin and now I've got a new slider made from ABS which should work well. The phillips head is lightly recessed for grease to fill and I will glue the washer into place. This looks like a very good solution for a part that breaks all too often. If you end up needing one of these, let me know, I'll sell it cheap. picts below: I'll add more picts when I get to install it probably this weekend. Phar
-
my pass side window broke so i nedd another one hmu if you got one thanks, Allen
-
my pass side window broke so i nedd another one hmu if you got one thanks, Allen
-
I'm looking for one driver side window for a 77 or 78 280z. PM me for a number to text. Located in West Texas.
-
Hi all, Not too long ago, the exterior door handle on my '76 280z stopped opening the door. When I pull on it, it seems that one side pops out a bit from the door itself. The interior handle works fine, however. Also, I'm trying to figure out how to get the window regulator rollers back onto the rails. I've gone through threads, my chiltons and haynes manuals, and general google searches but can't find any specific info on how it should get re-mounted. Any tips? Thanks, Pac-Man
