1971 240z ITB install

[DuffyMahoney]

Dual L6 knock sensors using the stock block m6 hot water pipe mounts. They are actually about perfectly placed! 
 

These are just ti prototype. I am designing my own and will be adding them to the things I make and sell. 

[DuffyMahoney]

Custom grade 5 titanium studs of my design. I am so tired of installing the old studs and I hate the look of the allen ones. I designed intake, exhaust, my intake balance banjos, knock sensor stud, stack studs and my intake intake/ throttle studs! The flat spots work perfect with a box wrench. I also love the look of a rounded tip on a stud. I think they came out awesome, after testing I will be selling. I bought enough, that they should be fairly cost effective as well.

Edited November 23, 2024 by DuffyMahoney

[DuffyMahoney]

Well I got my prototypes in for my passive cooling on my Efi hardware throttles! These will be between the heat shield and the throttle bodies. Also it will be a nice and clean way to run the return fuel.

[DuffyMahoney]

I love it when a plan comes together.  This is custom titanium banjos, which will come off my balance bar and hold my heat shield on! 

[DuffyMahoney]

240z hidden drive by wire actuator for my ITB setup. This is design number 4.

This plan utilizes a Efi hardware actuator. The goal is the same length arm to the bell crank and distances from shafts and the rod. So the rod passes through the firewall evenly and doesn’t walk from left to right.

This will mount to the pedal plate and the steering box mounts. So behind the firewall

Prior designs walked too much in the hole and I don’t want that.