MegaSquirt

1996 topics in this forum

1. EMS Pro help needed

   By tunerpike, September 3, 2012
   • 19 replies
   • 3.8k views
   • 
   • Matt Cramer
   • February 11, 2013

3. MS-I on l28et

   By JacobsZ, September 1, 2012
   • 5 replies
   • 2.7k views
   • 
   • s30red240z
   • September 3, 2012

4. New tech article: MegaSquirt Acceleration Enrichment Tuning

   By Matt Cramer, August 28, 2012
   • 3 replies
   • 2.9k views
   • 
   • DCZ
   • August 31, 2012

5. MS3 on 280zx stopped working

   By phi135, August 26, 2012
   • 2 replies
   • 1.1k views
   • 
   • dexter72
   • August 26, 2012

6. injector banks not firing and fidle not engaging relay 1 2

   By softopz, August 22, 2012
   • 32 replies
   • 6.7k views
   • 
   • softopz
   • October 25, 2012

7. Jeep Pencil coils MS2

   By MaTTSuN, August 21, 2012
   • 1 reply
   • 887 views
   • 
   • Matt Cramer
   • August 21, 2012

8. Ms 1 v2.2 Help!

   By Nelatl, August 16, 2012
   • 6 replies
   • 1.5k views
   • 
   • kaito
   • September 9, 2012

9. My IACV solution

   By adam78280z, August 13, 2012
   • 3 replies
   • 1.1k views
   • 
   • Leon
   • August 14, 2012

10. Misfire under boost after switching to ms2e

    By 83turbo280zx, August 12, 2012
    • 4 replies
    • 1.9k views
    • 
    • cws1807
    • May 6, 2013

11. Wiring with Bosch 7 Pin Module

    By PITA_Z, June 25, 2012
    • 1 reply
    • 2.5k views
    • 
    • NewZed
    • June 25, 2012

12. First L6 sequencer install?

    By Dan_Austin, June 24, 2012
    • 6 replies
    • 1.7k views
    • 
    • Dan_Austin
    • August 3, 2012

13. New tech article - understanding the different MS variants

    By Matt Cramer, June 14, 2012
    • 2 replies
    • 1.2k views
    • 
    • duragg
    • June 18, 2012

14. Driving the tach with coil packs

    By letitsnow, June 14, 2012
    • 9 replies
    • 2.8k views
    • 
    • Dan_Austin
    • August 21, 2012

15. Trying to swap a ’83 l28et distributor into a ’75 l28e to drive signal to my MS3 w/ MS3X.

    By Madovic, June 13, 2012
    • 12 replies
    • 1.2k views
    • 
    • SleeperZ
    • June 18, 2012

16. Start like a regular car? 1 2 3

    By MaTTSuN, June 6, 2012
    • 47 replies
    • 9.1k views
    • 
    • Racer Z
    • December 10, 2012

17. DIY CAS for L28ET angle settings 1 2

    By macambra, June 4, 2012
    • 26 replies
    • 8.3k views
    • 
    • SleeperZ
    • June 26, 2012

18. Start then stop

    By MaTTSuN, May 30, 2012
    • 8 replies
    • 1.6k views
    • 
    • MaTTSuN
    • June 5, 2012

19. Hesitation when lightly pressing the accelarator after a complete stop

    By 2s2mad, May 30, 2012
    • 17 replies
    • 14.1k views
    • 
    • MRL
    • March 2, 2019

20. Post Dyno Compression Test

    By BLOZ UP, May 26, 2012
    • 7 replies
    • 1.7k views
    • 
    • BLOZ UP
    • June 4, 2012

21. Ms1 misc o2 sensor

    By 1973240, May 26, 2012
    • 4 replies
    • 1.5k views
    • 
    • 1973240
    • June 8, 2012

22. Need help with my L28ET!

    By jacob80, May 22, 2012
    • 8 replies
    • 3.2k views
    • 
    • motomanmike
    • November 20, 2012

23. Need help getting 5v coil signal LS1.....

    By gearheadstik, May 15, 2012
    • 3 replies
    • 2.4k views
    • 
    • jacob80
    • May 17, 2012

24. Seeking help on MS2 installation and programing,

    By Beechgate z, May 14, 2012
    • 2 replies
    • 1.2k views
    • 
    • Beechgate z
    • May 15, 2012

25. Base timing changing for no reason

    By letitsnow, May 10, 2012
    • 3 replies
    • 1.5k views
    • 
    • letitsnow
    • May 11, 2012

26. Dash Comp Output Channels Not Configured? Tuner Studio

    By Challenger, May 9, 2012
    • 3 replies
    • 1.5k views
    • 
    • Challenger
    • May 18, 2012