MegaSquirt

2001 topics in this forum

1. Resistor question

   By Guest SurfColorado, June 27, 2005
   • 4 replies
   • 1.5k views
   • 
   • proxlamus©
   • June 27, 2005

3. Resistors

   By boosted280, April 11, 2009
   • 7 replies
   • 1.6k views
   • 
   • mobythevan
   • April 14, 2009

4. Resistors vs. PWM for injectors? 1 2

   By Zmanco, October 11, 2007
   • 34 replies
   • 10.8k views
   • 
   • Zmanco
   • October 21, 2007

5. Restrictor for MAP sensor 1 2 3

   By drews240, September 11, 2006
   • 58 replies
   • 17.8k views
   • 
   • HB280ZT
   • March 30, 2007

6. rev limit and some other stuff

   By midnightzxt, October 6, 2005
   • 1 reply
   • 1.1k views
   • 
   • proxlamus©
   • October 6, 2005

7. REV Limit control

   By trwebb26, December 30, 2005
   • 1 reply
   • 1.1k views
   • 
   • Thumper
   • December 30, 2005

8. Rev limiter and Overboost protection.. 40 degrees retard too much?

   By proxlamus©, May 30, 2006
   • 8 replies
   • 6k views
   • 
   • proxlamus©
   • June 1, 2006

9. REV Limiter?

   By evildky, April 18, 2005
   • 2 replies
   • 1.5k views
   • 
   • Tony D
   • April 18, 2005

10. Rich at idle and stumbles while accelerating

    By p901, February 25, 2008
    • 2 replies
    • 1.7k views
    • 
    • dexter72
    • February 26, 2008

11. Rich Idle l28et, with injector map.

    By Meguiars, September 7, 2014
    • 5 replies
    • 1.8k views
    • 
    • winstonusmc
    • September 9, 2014

12. Right after I get an MS-II...look!

    By cygnusx1, April 4, 2007
    • 14 replies
    • 2.9k views
    • 
    • trwebb26
    • April 8, 2007

13. rodney sparks harness wire kit-good stuff

    By randy 77zt, July 15, 2005
    • 0 replies
    • 1.1k views
    • 
    • randy 77zt
    • July 15, 2005

14. Roll-On throttle Leaning Out - Matt Kramer?

    By cygnusx1, September 26, 2007
    • 10 replies
    • 2.4k views
    • 
    • datman
    • March 31, 2008

15. rotary controlled fuel/ign box

    By datman, February 18, 2008
    • 3 replies
    • 1.2k views
    • 
    • datman
    • February 19, 2008

16. Rotating the tuning map?

    By cygnusx1, July 9, 2007
    • 2 replies
    • 1.2k views
    • 
    • cygnusx1
    • July 10, 2007

17. Rotor phasing

    By annoyingorange, May 11, 2016
    • 4 replies
    • 2.1k views
    • 
    • NewZed
    • May 11, 2016

18. RPM bouncing (3-500) in log, but drives ok

    By datsun74z_tn, March 6, 2016
    • 3 replies
    • 1.4k views
    • 
    • skirkland1980
    • March 8, 2016

19. rpm pot

    By Nismo280zEd, September 29, 2008
    • 5 replies
    • 1.6k views
    • 
    • Nismo280zEd
    • October 1, 2008

20. Rpm signal loss 1 2 3 4 7

    By seattlejester, March 12, 2014
    • 138 replies
    • 30.2k views
    • 
    • seattlejester
    • September 11, 2014

21. RPM spike

    By Zmanco, November 6, 2008
    • 15 replies
    • 3.3k views
    • 
    • Matt Cramer
    • November 11, 2008

22. RPM spike with MS3 and MSD 6al

    By seth1001, September 25, 2011
    • 8 replies
    • 5.6k views
    • 
    • seth1001
    • October 29, 2011

23. RRFPR or not?

    By jacob80, June 4, 2009
    • 9 replies
    • 4.2k views
    • 
    • mobythevan
    • June 8, 2009

24. RS232TO USB onboard conversion question

    By macambra, December 3, 2011
    • 7 replies
    • 2.5k views
    • 
    • BLOZ UP
    • August 9, 2012

25. Rules for Fuel Pump Speed Controller / Modulator

    By bherd, July 25, 2008
    • 4 replies
    • 1.9k views
    • 
    • bherd
    • July 25, 2008

26. Run and Crank Positions

    By rvandivort, September 16, 2008
    • 5 replies
    • 1.8k views
    • 
    • rvandivort
    • September 21, 2008