Trouble Shooting / General Engine

2134 topics in this forum

1. How to Bleed 280Z Clutch Master Cylinder by Yourself

   By SubaruBRZ, April 15, 2016
   • 8 replies
   • 6.3k views
   • 
   • seattlejester
   • April 15, 2016

3. SU Out of tune?? 1 2 3

   By at-jefft, June 1, 2009
   • 49 replies
   • 6.2k views
   • 
   • at-jefft
   • June 27, 2009

4. 280z won't start

   By gunskill, February 8, 2010
   • 6 replies
   • 6.2k views
   • 
   • Heathhh
   • February 10, 2010

5. No heater good or bad? 1 2

   By J240ZTurbo, July 10, 2010
   • 39 replies
   • 6.1k views
   • 
   • J240ZTurbo
   • July 15, 2010

6. Rb20DET Runs in limp mode

   By Stevemd24, December 20, 2013
   • 19 replies
   • 6.1k views
   • 
   • ihiryu
   • February 8, 2014

7. Water Temp Sender 1 2

   By pochie45566, September 30, 2018
   • 26 replies
   • 6.1k views
   • 
   • jhm
   • October 8, 2018

8. Engine woes- read on if you dare 1 2

   By madkaw, July 19, 2014
   • 37 replies
   • 6k views
   • 
   • madkaw
   • July 19, 2015

9. Cometic MLS Gasket - Small Coolant Leaks

   By AZGhost623, February 22, 2014
   • 16 replies
   • 6k views
   • 
   • NewZed
   • February 24, 2014

10. changing valve springs

    By Guest Anonymous, November 23, 2001
    • 15 replies
    • 6k views
    • 
    • Guest
    • December 11, 2001

11. Help! Running lights are dead on my '72 240z, any clues?

    By josh817, April 28, 2010
    • 11 replies
    • 5.8k views
    • 
    • kce
    • January 18, 2011

12. looking for help tuning Triple webers

    By stav2201, February 11, 2014
    • 15 replies
    • 5.8k views
    • 
    • duragg
    • February 28, 2014

13. HELP! Should the volt meter on a '76 280Z be ON when the car is OFF

    By Hardwyre, January 12, 2010
    • 15 replies
    • 5.8k views
    • 
    • Hardwyre
    • February 11, 2010

14. 1978 280Z Heater Core Bypass Help

    By oki_all_day, January 17, 2016
    • 8 replies
    • 5.8k views
    • 
    • seattlejester
    • January 20, 2016

15. Headlights won't turn off?

    By Charles Patterson, August 29, 2006
    • 12 replies
    • 5.8k views
    • 
    • fastzcars
    • September 8, 2006

16. Well, I just joined the 'I popped a Core Plug' Club... 1 2

    By Guest 280ZForce, October 26, 2006
    • 24 replies
    • 5.7k views
    • 
    • Guest
    • October 29, 2006

17. Stuck Slave (Release) Cylinder

    By tsabboi, June 26, 2011
    • 6 replies
    • 5.7k views
    • 
    • roger.svoboda
    • June 30, 2011

18. Help! my 240z wont go pass4000RPM!!

    By Jonas240z, November 3, 2004
    • 11 replies
    • 5.7k views
    • 
    • datsunlover
    • November 29, 2004

19. big problems with my 1986 300ZX Turbo

    By Boriqueazy300ZXT, October 4, 2007
    • 4 replies
    • 5.6k views
    • 
    • george.bryant
    • October 31, 2007

20. 77 280z odd timing, stuttering, hesitation on throttle

    By ISPKI, May 26, 2014
    • 15 replies
    • 5.6k views
    • 
    • ISPKI
    • August 15, 2014

21. l28et s30 swap bad sputtering 1 2

    By 240z72, June 13, 2012
    • 37 replies
    • 5.5k views
    • 
    • Tony D
    • February 16, 2013

22. Won't start after fuel rail upgrade 1 2

    By Turbo_the_world, June 17, 2016
    • 27 replies
    • 5.5k views
    • 
    • Turbo_the_world
    • June 27, 2016

23. Slipping Harmonic Balancer Pulley

    By Nigel, August 5, 2008
    • 10 replies
    • 5.4k views
    • 
    • Tony D
    • August 19, 2008

24. L28et swap RICH in the >10 AFR's, AFM at idle? 1 2 3

    By SDgoods, January 20, 2013
    • 45 replies
    • 5.4k views
    • 
    • SDgoods
    • January 29, 2013

25. l28ET Z31 ECU/MAF leans out 3500 RPM on the dot, Any driving load. 1 2

    By SDgoods, September 24, 2013
    • 33 replies
    • 5.4k views
    • 
    • SDgoods
    • October 27, 2013

26. L24 trouble after installing Pertronix Electronic Ignition

    By Cbb, March 8, 2014
    • 7 replies
    • 5.3k views
    • 
    • Cbb
    • March 22, 2014