Trouble Shooting / General Engine

2134 topics in this forum

1. Changed Trans Fluid and found this, should i be worried?

   By dvorak, September 30, 2014
   • 4 replies
   • 1.2k views
   • 
   • RebekahsZ
   • October 28, 2014

3. Another sidedraft question

   By wesmc, October 24, 2014
   • 0 replies
   • 958 views
   • 
   • wesmc
   • October 24, 2014

4. HOT Fusible Link!

   By Turbo260Z, October 16, 2014   

   • 260z
   • Fusible
   • (and 5 more)

     Tagged with:

     • 260z
     • Fusible
     • Link
     • Hit
     • Hot
     • Ignition
     • Relay
   • 4 replies
   • 3k views
   • 
   • NewZed
   • October 17, 2014

5. 77 280z breaking up in higher revs

   By bizzyboi904, October 12, 2014
   • 1 reply
   • 870 views
   • 
   • NewZed
   • October 12, 2014

6. Where does this (missing) vacuum line go?

   By alejohndro5, October 6, 2014   

   • vacuum line missing
   • 2 replies
   • 993 views
   • 
   • alejohndro5
   • October 7, 2014

7. Tail lights don't work

   By ktmccrackin, September 25, 2014
   • 4 replies
   • 1.4k views
   • 
   • Mike kZ
   • September 26, 2014

8. 280z heat and low.rev bucking

   By spenc96, September 12, 2014   

   • s30datsun
   • 280z
   • 3 replies
   • 1.2k views
   • 
   • NewZed
   • September 12, 2014

9. 280Z won't idle, has no power, and dies randomly.

   By Jt.drummer7, August 22, 2014
   • 6 replies
   • 1.6k views
   • 
   • Jt.drummer7
   • September 12, 2014

10. 1973 240Z Won't start

    By Jordon, June 2, 2014
    • 4 replies
    • 2.1k views
    • 
    • Tony D
    • September 7, 2014

11. 77 280z odd timing, stuttering, hesitation on throttle

    By ISPKI, May 26, 2014
    • 15 replies
    • 5.6k views
    • 
    • ISPKI
    • August 15, 2014

12. Cylinder #2 not firing - Mikuni jetting

    By ryant67, August 2, 2014
    • 14 replies
    • 1.3k views
    • 
    • ryant67
    • August 11, 2014

13. Modular Problem

    By Black_Out_280Z, July 31, 2014
    • 5 replies
    • 880 views
    • 
    • NewZed
    • July 31, 2014

14. Best ignition switch 1 2

    By Rob L, July 9, 2014
    • 21 replies
    • 2.7k views
    • 
    • ryant67
    • July 20, 2014

15. Rust on Cams, is there a good legit way to polish the rust off?

    By 4.6StangRage, June 29, 2014
    • 3 replies
    • 1.6k views
    • 
    • Domzs
    • June 29, 2014

16. 280Z runs lean after 4000rpm

    By Serban, June 23, 2014
    • 19 replies
    • 2.9k views
    • 
    • Tony D
    • June 27, 2014

17. Battery wired up backwards

    By _Donovan_, June 13, 2014
    • 11 replies
    • 1.8k views
    • 
    • _Donovan_
    • June 24, 2014

18. 78 280z fuel pressure off and on

    By jdbaker77, June 8, 2014
    • 2 replies
    • 1k views
    • 
    • osirus9
    • June 21, 2014

19. 280zx Turbo start up problem.

    By jbh1212, June 12, 2014
    • 1 reply
    • 809 views
    • 
    • NewZed
    • June 12, 2014

20. Here's a fun one. 5000 RPM cut and misfires

    By Watson, June 7, 2014
    • 3 replies
    • 1.1k views
    • 
    • Domzs
    • June 8, 2014

21. vacuum line route for 83 280zxt

    By Mr.Twitty, June 6, 2014
    • 0 replies
    • 746 views
    • 
    • Mr.Twitty
    • June 6, 2014

22. car stalls, then recovers, in motion

    By heavyweight280, June 3, 2014
    • 1 reply
    • 980 views
    • 
    • NewZed
    • June 4, 2014

23. transmission bolt identification help[solved]

    By Milenko2121, June 2, 2014
    • 1 reply
    • 737 views
    • 
    • Milenko2121
    • June 2, 2014

24. 1983 280zx will not idle, bad hesitation

    By dukemushroom918, May 30, 2014
    • 5 replies
    • 1.2k views
    • 
    • Domzs
    • May 31, 2014

25. 1976 hard time idling after AC and heater removal

    By dpuma8, May 29, 2014
    • 1 reply
    • 886 views
    • 
    • NewZed
    • May 29, 2014

26. 280zx Oil Temp Sensor thread size?

    By Milenko2121, March 25, 2014
    • 1 reply
    • 1.2k views
    • 
    • Milenko2121
    • May 21, 2014