Jump to content
HybridZ

mattb3562

Members
  • Posts

    161
  • Joined

  • Last visited

Everything posted by mattb3562

  1. It sounds to me as if the fuel system is doing what its supposed to...have you checked for loss of during these intermittent fits?
  2. This will have the rb guys drooling! Nice work!
  3. I've got one with the duct that goes over the valve cover. I don't have the bolts but I'll take $25 shipped for the fan and duct
  4. I have a zxt coil and ignitor that I believe will work a lot better for you than the n/a coil...
  5. Thanks guys. I'm gonna call around next week and get something lined up for February.
  6. I've gotten so aggravated trying to tune my car, I'm gonna get a shop to do it. Does anyone know of a good shop around atl, ga that is good with megasquirt and knows our engines well?
  7. I have a set that have been in my garage for 2 years and have no idea if they work or not....may clean up and work, but may not. I would do $40 shipped, if that helps you any.
  8. Or a 240sx 5spd. Its documented on blues tech tips.
  9. Or a 240sx 5spd. Its documented on blues tech tips.
  10. Very similar, but I turned down the second row of my pulley, as I'm not running a/c. However, a hub could be made to bolt to the pulley and then to the wheel.
  11. This is the DIY wheel mounted to the turbo crank pulley. It could be ran with a/c with the vr sensor mounted on the other side of the "left" side.
  12. Are you getting a 5 sec prime with key "on"?
  13. If it'll communicate with megatune properly, it should work with tunerstudio just fine.
  14. I run ms and a 300 watt amp on my l28et car with a 70 amp alternator
  15. Are you getting rpms in software and showing a crank trigger while cranking?
  16. Yeah, send me your email and I'll send you some pics
  17. Oh, and I have the same setup running on MS1Extra and it pulls insanely. The only thing that I would recommend is to strongly consider EDIS. I've got mine tore back apart installing crank triggered ignition. Went down a long, hard road with the turbo dizzy. Not to say they don't work....just didn't for me.
  18. I have an mad coil and wires that were built for an l28et. $50 plus shipping. I also have a walbro 255. $50 plus shipping. I have an eBay regulator that would serve the purpose for $10 if you wanted it, too. Maybe other odds and ends, but I will have to look and see.
  19. Why not just bolt one of the carbed intakes on and crank it with a screwdriver and some gas in the carbs to get it primed? U can run a fused hot wire to the fuel pump on a switch and manually regulate it...
  20. Man, this was like reading a 40 chapter book with the last 10 pages ripped out!
  21. I sure would love to see some more of this car...on the road? Dyno numbers? 1/4 E.T.?I recently acquired one of these engines and debating on going through the trouble down the road.
  22. I took this pic of a 2014 civic. Most beautiful color I've ever seen. This pic doesn't do justice to how it stands in the sunlight. Its blue/teal depending on the flop.
  23. Here ya go... http://www.atlanticz.ca/zclub/techtips/cam/index.htm
  24. That's gonna look wicked with a 3 or 4" cowl hood. Its gonna look like a SBC car with a wild turbo sound!
×
×
  • Create New...