Jump to content
HybridZ

MegaSquirt

Discussions of technical related subjects pertaining to the MegaSquirt FI system.

1996 topics in this forum

  1. 76 280z microsquirt project 1 2

    By darom,
    • 35 replies
    • 1.8k views

  3. Turbo Timing Safety Check

    By Flak280z,
    • 1 reply
    • 258 views

  4. EDIS Tach Signal - Combine Negative Coil Signals 1 2

    By TrumpetRhapsody,
    • 28 replies
    • 7.5k views

  5. MS2-v3.57 AFR, FE, IGN table check

    By Jersey,
    • 10 replies
    • 678 views

  6. Ms3x install 1 2 3 4 16

    By madkaw,   
    • 310 replies
    • 55.6k views

  7. Megasquirt 2 3.57 No start, timing issue?

    By Flak280z,
    • 17 replies
    • 845 views

  8. Need help with 280ZX N/A tune

    By seth1001,
    • 1 reply
    • 491 views

  9. 78 280 ms2 3.57 dizzy/ignition wiring

    By Flak280z,
    • 15 replies
    • 899 views

  10. Major voltage spikes and sags with Megasquirt II 3.0

    By Datsun Deron,
    • 10 replies
    • 6.5k views

  11. Chickenman Remote Tune Service Review

    By Slowpoke,
    • 9 replies
    • 3.8k views

  12. 81 ZX turbo, died on the road, no spark. 1 2

    By HICKL,
    • 21 replies
    • 2.7k views

  13. DIYAutoTune MegaSquirt MS3Pro Ultimate dual tps and ica?

    By Darren J Helms,   
    • 0 replies
    • 590 views

  14. Help - Drivable Base Tune 83 280zx upgrade with MS3

    By taijirich,
    • 2 replies
    • 695 views

  15. Megasquirt Tuning in Portland, OR

    By 240zdreamin,
    • 0 replies
    • 448 views

  16. Looking to get into Megasquirt Diy kit

    By Zellthetunerr,
    • 15 replies
    • 2.5k views

  17. Jeep Cam angle sensor for L - Series 1 2 3

    By jacky4566,
    • 48 replies
    • 16.3k views

  18. MS2 or MS3

    By kintZugi,
    • 2 replies
    • 1.1k views

  19. cold start sync loss

    By madkaw,
    • 0 replies
    • 672 views

  20. Need Help Finishing MS2 Install

    By geeksteev,
    • 9 replies
    • 2.4k views

  21. Remote Tuning

    By taaron,
    • 1 reply
    • 1.1k views

  22. L28ET base settings and tables?

    By Barrel_Ball,
    • 4 replies
    • 3.5k views

  23. High noise in TPS sensor wire when Wideband uses sensor ground

    By 79er,
    • 1 reply
    • 1.2k views

  24. Cam Fault with Full Sequential COP

    By jkelly,
    • 5 replies
    • 4.7k views

  25. 100% Injector dead time vs Voltage

    By 79er,
    • 3 replies
    • 1.9k views

  26. MS2 V3 Fuel only to Fuel and Spark

    By 2s2mad,   
    • 4 replies
    • 1.6k views
×
×
  • Create New...